Chapter 32 Error Disable
The following table describes the labels in this screen.
Table 104 Advanced Application > Errdisable > CPU protection
LABEL | DESCRIPTION |
Reason | Select the type of control packet you want to configure here. |
|
|
Port | This field displays the port number. |
|
|
* | Use this row to make the setting the same for all ports. Use this row first |
| and then make adjustments to each port if necessary. |
| Note: Changes in this row are copied to all the ports as soon as you |
| make them. |
|
|
Rate Limit | Enter a number from 0 to 256 to specify how many control packets this |
(pkt/s) | port can receive or transmit per second. |
| 0 means no rate limit. |
| You can configure the action that the Switch takes when the limit is |
| exceeded. See Section 32.5 on page 311 for detailed information. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
32.5 Error-Disable Detect Configuration
Use screen to have the Switch detect whether the control packets exceed the rate limit configured for a port and configure the action to take once the limit is exceeded. Click the Click Here link next to Errdisable Detect link in the Advanced Application > Errdisable screen to display the screen as shown.
Figure 150 Advanced Application > Errdisable > Errdisable Detect
| 311 |
|
|