Chapter 27 Loop Guard
The following table describes the labels in this screen.
Table 89 Advanced Application > Loop Guard
LABEL | DESCRIPTION |
Active | Select this option to enable loop guard on the Switch. |
| The Switch generates syslog, internal log messages as well as SNMP traps |
| when it shuts down a port via the loop guard feature. |
|
|
Port | This field displays a port number. |
|
|
* | Use this row to make the setting the same for all ports. Use this row first |
| and then make adjustments on a |
| Note: Changes in this row are copied to all the ports as soon as you |
| make them. |
|
|
Active | Select this check box to enable the loop guard feature on this port. The |
| Switch sends probe packets from this port to check if the Switch it is |
| connected to is in loop state. If the Switch that this port is connected is in |
| loop state the Switch will shut down this port. |
| Clear this check box to disable the loop guard feature. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
286 |
| |
| ||
|
|
|