Chapter 45 Maintenance
Table 141 | Management > Maintenance (continued) | |
LABEL |
| DESCRIPTION |
Save |
| Click Config 1 to save the current configuration settings to Configuration |
Configurati |
| 1 on the Switch. |
on |
| Click Config 2 to save the current configuration settings to Configuration |
|
| |
|
| 2 on the Switch. |
|
|
|
Reboot |
| Click Config 1 to reboot the system and load Configuration 1 on the |
System |
| Switch. |
|
| Click Config 2 to reboot the system and load Configuration 2 on the |
|
| Switch. |
|
| Note: Make sure to click the Save button in any screen to save your |
|
| settings to the current configuration on the Switch. |
|
|
|
45.2 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all Switch configuration information you configured and return to the factory defaults.
2Click OK to reset all Switch configurations to the factory defaults.
Figure 211 Load Factory Default: Start
3In the web configurator, click the Save button to make the changes take effect. If you want to access the Switch web configurator again, you may need to change the IP address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).
45.3Save Configuration
Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.
390 |
| |
| ||
|
|
|