Chapter 49 Cluster Management
49.3 Clustering Management Configuration
Use this screen to configure clustering management. Click Configuration from the Cluster Management screen to display the next screen.
Figure 238 Management > Clustering Management > Configuration
The following table describes the labels in this screen.
Table 165 Management > Clustering Management > Configuration
LABEL | DESCRIPTION |
Clustering |
|
Manager |
|
|
|
Active | Select Active to have this Switch become the cluster manager switch. |
| A cluster can only have one manager. Other (directly connected) |
| switches that are set to be cluster managers will not be visible in the |
| Clustering Candidates list. If a switch that was previously a cluster |
| member is later set to become a cluster manager, then its Status is |
| displayed as Error in the Cluster Management Status screen and a |
| warning icon ( ) appears in the member summary list below. |
|
|
Name | Type a name to identify the Clustering Manager. You may use up to |
| 32 printable characters (spaces are allowed). |
|
|
VID | This is the VLAN ID and is only applicable if the Switch is set to |
| 802.1Q VLAN. All switches must be directly connected and in the |
| same VLAN group to belong to the same cluster. Switches that are not |
| in the same VLAN group are not visible in the Clustering Candidates |
| list. This field is ignored if the Clustering Manager is using Port- |
| based VLAN. |
|
|
440 |
| |
| ||
|
|
|