Chapter 32 Error Disable
32.6 Error-Disable Recovery Configuration
Use this screen to to configure the Switch to automatically undo an action after the error is gone. Click the Click Here link next to Errdisable Recovery in the Advanced Application > Errdisable screen to display the screen as shown.
Figure 151 Advanced Application > Errdisable > Errdisable Recovery
The following table describes the labels in this screen.
Table 106 Advanced Application > Errdisable > Errdisable Recovery
LABEL | DESCRIPTION |
Active | Select this option to turn on the |
| Switch. |
|
|
Reason | This field displays the supported features that allow the Switch to shut |
| down a port or discard packets on a port according to the feature |
| requirements and what action you configure. |
|
|
* | Use this row to make the setting the same for all entries. Use this row |
| first and then make adjustments to each entry if necessary. |
| Note: Changes in this row are copied to all the entries as soon as you |
| make them. |
|
|
Timer Status | Select this option to allow the Switch to wait for the specified time |
| interval to activate a port or allow specific packets on a port, after the |
| error was gone. Deselect this option to turn off this rule. |
|
|
Interval | Enter the number of seconds (from 30 to 2592000) for the time interval. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
| 313 |
|
|