Chapter 54 Configure Clone

The following table describes the labels in this screen.

Table 170 Management > Configure Clone

LABEL

DESCRIPTION

Source/

Enter the source port under the Source label. This port’s attributes are

Destination

copied.

Port

Enter the destination port or ports under the Destination label. These are

 

the ports which are going to have the same attributes as the source port.

 

You can enter individual ports separated by a comma or a range of ports by

 

using a dash.

 

Example:

 

2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.

 

2-6indicates that ports 2 through 6 are the destination ports.

 

 

Basic

Select which port settings (configured in the Basic Setting menus) should

Setting

be copied to the destination port(s).

 

 

Advanced

Select which port settings (configured in the Advanced Application

Application

menus) should be copied to the destination ports.

 

 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The

 

Switch loses these changes if it is turned off or loses power, so use the

 

Save link on the top navigation panel to save your changes to the non-

 

volatile memory when you are done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

456

 

XGS-4526/4528F/4728F User’s Guide