Orion Car Audio XTR15001, XTR10001, XTR5001 owner manual Warranty

Page 102

WARRANTY

LIMITED ONE-YEAR CONSUMER WARRANTY/*LIMITED TWO-YEAR CONSUMER WARRANTY FOR AUTHORIZED DIRECTED DEALER PURCHASE & INSTALLATION

Directed Electronics (herein “Directed”) promises to the original purchaser of the subwoofer or amplifier, as applicable (herein “Unit” or “Product”), to repair or replace with a new or re- furbished Unit (at Directed’s sole and absolute discretion) should the Unit prove to be defective in workmanship or material under normal use, for a period of *two-years from the date of purchase from the authorized Directed dealer PROVIDED the Unit was purchased and installed by an authorized Directed dealer. During this *two-year period, there will be no charge for the repair or replacement PROVIDED the Unit is returned to Directed (DO NOT RETURN THE ENTIRE ENCLOSURE. PLEASE RETURN THE WARRANTIED UNIT ONLY.), shipping prepaid, along with the required proof of installation, the bill of sale or other dated proof of purchase, and the consumer’s contact information. If the Unit is installed by anyone other than an authorized Directed dealer, the warranty period will be one-year from the date of purchase. This warranty is non-transferable and does not apply to any Unit that has been modified or used in a manner contrary to its intended purpose, and does not cover damage to the Unit caused by installation or removal of the Unit. During this one-year period, there will be no charge for the repair or replacement PROVIDED the Unit is returned to Directed, shipping pre-paid, along with the bill of sale or other dated proof of purchase and the consumer’s contact information. This warranty is void if the product has been damaged by accident or unreasonable use, neglect, improper service or other causes not arising out of defects in materials or construction. This warranty does not cover the elimination of externally generated static or noise, or the correction of antenna problems or weak reception, damage to speakers, accessories, electrical systems, cosmetic damage or damage due to negligence, misuse, failure to follow operating instructions, accidental spills or customer applied cleaners, damage due to environmental causes such as floods, airborne fallout, chemi- cals, salt, hail, lightning or extreme temperatures, damage due to accidents, road hazards, fire, theft, loss or vandalism, damage due to improper connection to equipment of another manu- facturer, modification of existing equipment, or Product which has been opened or tampered for any reason. Units which are found to be damaged by abuse resulting in thermally damaged voice coils are not covered by this warranty but may be replaced at the absolute and sole discretion of Directed. Unit must be returned to Directed (DO NOT RETURN THE ENTIRE ENCLOSURE. THE UNIT ENCLOSURE IS COVERED BY A SEPARATE 90-DAY LIMITED CONSUMER WARRANTY. PLEASE ONLY RETURN THE WARRANTIED UNIT UNLESS A WARRANTY CLAIM IS BEING MADE FOR THE ENCLOSURE.), postage pre-paid, with bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number, and address, authorized dealer’s name and address, and product description. Unit must be returned to the following address: ATTN: WARRANTY DEPARTMENT, Directed Electronics , 1 Viper Way, Vista, CA 92081. Note: This warranty does not cover labor costs for the removal and/or reinstallation of the Unit. IN ORDER FOR THE TWO-YEAR WARRANTY TO BE VALID, YOUR UNIT MUST BE SHIPPED WITH PROOF OF INSTALLATION BY AN AUTHORIZED DIRECTED DEALER. ALL UNITS RECEIVED BY DIRECTED FOR WARRANTY REPAIR WITHOUT PROOF OF DIRECTED DEALER INSTALLATION AND PURCHASE WILL BE COVERED BY THE LIMITED 1 YEAR WARRANTY.

BY PURCHASING THIS PRODUCT, ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICU- LAR PURPOSE, AND WARRANTY OF NON-INFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. IN NO EVENT WILL DIRECTED BE LIABLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES (INCLUDING LOSS OF PROFITS). BY PURCHASING THIS PRODUCT, THE CONSUMER AGREES AND CONSENTS THAT ALL DISPUTES BETWEEN THE CONSUMER AND DIRECTED SHALL BE RESOLVED IN ACCORDANCE WITH CALIFORNIA LAWS IN SAN DIEGO COUNTY, CALIFORNIA. This warranty is only valid for sale of Product within the United States of America. Product sold outside of the United States of America is sold “AS-IS,” and shall have NO WARRANTY, express or implied. Some states do not allow limitation on how long an implied warranty lasts. In such states, the limitation or exclusions of this Limited Warranty may not apply. Some states do not allow the exclusion or limitation of incidental or consequential damages. In such states, the exclusion or limitation of this Limited Warranty may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights which vary from state to state.

920-0033 04-07

For more information on Orion products please visit www.orioncaraudio.com

Directed Electronics is an

ISO 9001 registered company.

Directed Electronics is committed to delivering world class quality products and services that excite and delight our customers.

 

 

Vista, CA 92081

© 2009 Directed Electronics. All rights reserved.

GXTR5001 2009-02

w w w. d i r e c t e d . c o m

Image 102
Contents Amplifier Contents Introduction Low-Pass Frequency LPF Control adjusts the frequency Infrasonic Subsonic Switch when On cuts off extremely lowCEA Specifications Specifications Input Gain Signal Input and Output ConfigurationsAdjusting Bass Boost Subsonic FilterSealed Example High-Pass Set at 20Hz Phase Switches Line Output Configurations System ExpansionSealed Example High-Pass Set at 30Hz Internal Crossover Configurations Low-Pass CrossoverRemote Gain Operation Power Connections for the XTR5001, XTR10001 and XTR15001 Speaker ConnectionsBridging strapping Master AmplifierPassenger Compartment General Precautions and Installation TipsChoosing Mounting Locations Trunk CompartmentTools of the Trade Step By Step Installation Testing the System Adjusting the Sound of the SystemAmplifier Visual Troubleshooting Amplifier Top Plate Troubleshooting Tips Symptom Probable Cause Action To TakeSymptom Probable Cause Directed Electronics. All rights reserved Français Disposition DES Panneaux LatérauxCaractéristiques Techniques CEA Caractéristiques Techniques Gain d’entrée Configurations d’entrée et de sortie du signalRéglages DE L’AMPLIFICATEUR Réglage du renforcement des gravesRéglage passe-haut à 20 Hz dans le cas d’un cais- son clos Commutateurs de phaseConfigurations de sortie ligne extension du sys- tème Réglage passe-haut à 30 Hz dans le cas d’un cais- son closConfiguration des filtres internes Utilisation de la télécommande du gainFiltre passe-bas Raccordement DE L’AMPLIFICATEUR Raccordement des haut-parleursPontage Précautions générales et conseils d’installation Installation DE L’AMPLIFICATEURChoix des emplacements de montage HabitacleOutillage requis Installation pas à pas Réglage ET Résolution DES Problèmes Essai du systèmeRéglage du son du système Résolution visuelle des problèmes de l’amplificateur Plaque supérieure de l’amplificateur Conseils de dépannage Symptôme Cause probable InterventionFrançais Symptôme Cause probable Español Disposiciones DEL Panel DE ExtremoEspecificaciones DE LA CEA THD+NEspecificaciones Configuraciones DEL Amplificador Caja sellada, pasaaltas en 20 Hz Configuraciones de salida de línea Expansión del sistemaConfiguraciones del crossover interno Caja cerrada, pasaaltas en 30 HzCrossover de pasabajas Control de amplificación a distanciaCableado DEL Amplificador Conexiones de altavocesConexión en puente Compartimiento de pasajeros Instalación DEL AmplificadorSelección de ubicaciones de montaje MaleteroHerramientas DEL Oficio Instalación paso a paso Configuración Y Detección Y Reparación DE Averías Prueba del sistemaDetección y reparación visual de averías del ampli- ficador Placa superior del amplificador Sugerencias de detección y reparación de averías Síntoma Causa probable Medidas a tomarEspañol Síntoma Causa probable Deutsch Layout DER EndplattenCEA-DATEN Technische Daten RGC2Eingangsverstärkung Signaleingangs- und -ausgangskonfigurationenVerstärkereinstellungen Subsonic-FilterBeispiel Geschlossenes Gehäuse, Hochpassfilter bei 30 Hz PhasenwahlschalterBeispiel Geschlossenes Gehäuse, Hochpassfilter bei 20 Hz Line-Ausgangskonfigurationen SystemerweiterungInterne Crossover-Konfigurationen Tiefpass-CrossoverBetrieb der Fernverstärkungsfunktion Lautsprecheranschlüsse VerstärkerverkabelungStromanschlüsse für den XTR5001, XTR10001 und XTR15001 Brückenmodus KoppelungWahl der Einbaustelle VerstärkerinstallationAllgemeine Vorsichts- und Installationshinweise FahrgastraumWerkzeuge Schrittweise Installation Einstellung UND Problemlösung SystemtestSystemsound einstellen Visuelle Anzeige von Problemen mit dem Verstärker Obere Platte des Verstärkers Problemlösungen Symptom Mögliche Ursache LösungSymptom Mögliche Ursache LösungDirected Electronics. Alle Rechte vorbehalten Italiano Layout DEI Pannelli TerminaliSpecifiche CEA Dati Tecnici Guadagno d’ingresso Configurazione dei segnali d’ingresso e di uscitaImpostazioni DELL’AMPLIFICATORE Filtro subsonicoConfigurazioni dell’uscita di linea espansione dell’impianto Selettore della faseConfigurazione dei crossover interni Crossover passa-bassoComando del guadagno a distanza Cablaggio DELL’AMPLIFICATORE Connessioni con gli altoparlantiCollegamento in parallelo Precauzioni generali e suggerimenti per l’installazione Installazione DELL’AMPLIFICATOREScelta del punto di installazione AbitacoloCorredo per l’installazione Procedura di installazione Impostazione E Soluzione DEI Problemi Prova dell’impiantoRegolazione dell’audio dell’impianto Spie dell’amplificatore Piastra superiore dell’amplificatore Soluzione dei problemi Sintomo Causa probabile Intervento necessarioItaliano Sintomo Causa probabile Português Layouts DOS PainéisEspecificações DA CEA Especificações Ganho de entrada Configurações de entrada e saída dos sinaisAjustes do Amplificador Ajuste da intensificação de gravesExemplo de caixa selada com passa-alta ajustado a 20 Hz Configurações da saída de linha expansão do sistemaConfigurações do crossover interno Exemplo de caixa selada com passa-alta ajustado a 30HzCrossover passa-baixa Operação de ganho remotoConexões dos alto-falantes Conexão DOS Cabos do AmplificadorConexões elétricas do XTR5001, XTR10001 e XTR15001 Ligação em ponte interligaçãoCabine de passageiros Instalação do AmplificadorEscolha de locais de instalação Porta-malasFerramentas Instalação passo a passo Ajuste E Resolução DE Problemas Como testar o sistemaComo ajustar o som do sistema Identificação visual de problemas com o amplifi- cador Placa superior do amplificador Sugestões para resolução de problemas Problema Provável causa Medida a ser tomadaInterno deste manual Directed Electronics. Todos os direitos reservados 100 Warranty