1.+BAT - connect this terminal through a FUSE or CIRCUIT BREAKER to the positive terminal of the vehicle battery or the positive ter- minal of an isolated audio system battery..
WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection..
2.REM - this terminal turns on the amplifier when (+) 12 volt is applied.. Connect it to the remote turn on lead of the head unit or signal source.. If a (+) 12 volt remote turn lead is not available, a Remote Power Adapter (P/N #ORRPA) can be used to supply a remote turn on signal.. DO NOT connect this terminal to constant
(+) 12 volt..
3.GND - power return connection.. Connect this terminal directly to the sheet metal chassis of the vehicle, using the shortest wire necessary to make this connection.. Always use wire of the same gauge or larger than the (+) 12 volt power wire.. The chassis con- nection point should be scraped free of paint and dirt.. Use only quality crimped and/or soldered connectors at both ends of this wire.. DO NOT connect this terminal directly to the vehicle battery ground terminal or any other factory ground points..
CEA Specifications
XTR5001
Power Output: 150 Watts RMS x 1 at 4 ohms and
< 1% THD+N
Signal to Noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 600 Watts RMS x 1 at 1 ohm and < 1% THD+N
XTR10001
Power Output: 300 Watts RMS x 1 at 4 ohms and
< 1% THD+N
Signal to Noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 1200 Watts RMS x 1 at 1 ohm and < 1% THD+N
XTR15001
Power Output: 400 Watts RMS x 1 at 4 ohms and
< 1% THD+N
Signal to Noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 1600 Watts RMS x 1 at 1 ohm and < 1% THD+N
© 2008 Directed Electronics. All rights reserved. | 4 |