Schwinn 438 manual Attach the Sub Pedal Arm Assemblies and Crank Covers, Figure A-6

Step 6—Attach the Sub Pedal Arm Assemblies and Crank Covers

Parts

#17 Sub Pedal Arm Assy (Qty 2)

#20 Right Crank Cover (Qty 1)

#21 Left Crank Cover (Qty 1)

Hardware

#32 12.5x25x1.0T Arc Washer (Qty 4)

#33 10.2x25x1.5T Flat Washer (Qty 2)

#34 10x1.5 Nylon Hex Nut (Qty 2)

#41 4x16 Self-Tapping Round Head Screw (Qty 2)

6–1Place the Sub Pedal Arm Assembly (#17), two (2) Arc Washers (#32), and one (1) Flat Washer (#33) on the right Pivot Tube (#22), as shown in the figure close-up below.

6–2Install the Nylon Hex Nut (#34) on the right Pivot Tube bolt.

6–3Align the Wheel on the Sub Pedal Arm Assembly (#17) in the track on the Rear Rail Assembly.

6–4Place the Right Crank Cover (#20) on the right Pivot Tube

(#22).

6–5Secure the Right Crank Cover

(#20) with the Self-Tapping

Round Head Screw (#41).

6–6Repeat steps 6–1 through 6–5 for the left Pivot Tube using the Left Crank Cover (#21).

ASSEMBLY INSTRUCTIONS

	34	33	17	34
41
		32		33

21

17

32 32

Track

22

22

20

41

17

Figure A–6

11