Haier AS09QS2ERA Operation, Clock set, Loading of the battery, Inner side of the controller

Operation

	Inner side of the controller
							the panel display “01”, the
		SMART					operating power is 100W;
			SET TEMP. ROOM TEMP.				when the panel display
		COOL					“02”, the operating power
		HEAT					is 200W, and so forth)
		FAN
		DRY					21. POWER button
		CTD	AUTO	AUTO	AUTO
		POWER	FAN				22. LIGHT button
English			SPEED
		SOFT					Control the lightening and
		ECO
		iFP	AM	TIMER ON	OFF		extinguishing of the indoor
							LED display board.
			PM
	25					26	23. HEALTH AIRFLOW button
	24	QUIET					24. HEALTH button
						27
							25. SMART button
	23	SMART		SLEEP		28
							Used to set SMART
				10		29	operation. (This function
	22					30	is unavailable on some
				CHILD

2Load the batteries as illustrated. 2 R-03 batteries,

resetting key (cylinder); Be sure that the loading is in line with the “+”/“-”;

3

Load the battery, then put on the cover again.

Clock set

1Press CLOCK button,

LIGHT	LOCK	models.)
21		31
	FRESH	26. SLEEP button
		32
20		27. 10 ºC button
		special heating set
19		33
		function: 10 degree
18		heating maintaining
		(valuable for RS)

AM

PM

QUIET

2Press “+” or “-” to set correct time.

18.	CODE button
	Used to select CODE A or B
	with a press, A or B will be
	displayed on LCD. Please
	select A without special
	explanation.
19.	RESET button
	When the remote controller
	appears abnormal, use

28.	CHILDLOCK button
	If pressed, the other
	buttons will be disabled.
	Press it once again, lock
	will be cancelled.
29.	FRESH button
30.	TIMER ON / OFF button
31.	HOUR button

SMART	SLEEP
	10
LIGHT	CHILD
	LOCK
	FRESH

Each press will increase or decrease 1min. If the button is kept pressed, time will change quickly.

3

a sharp pointed article to

press this button to reset

the controller normal.

20. INQUIRE button

Inquire the external

environmental temperature

and the operating power

of the machine. (e.g. when

	used to change clock or
	timer
32.	CANCEL/CONFIRM
	button
	clock settings.
33.	CLOCK button

press CONFIRM, “AM” and

starts working.

Note:

The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle

The following functions and related displays are not available: 20

Loading of the battery

1

Remove the battery cover;

change-over wireless telephone is installed in the type

in receiving the signals, so the distance to the indoor unit should be shorter.

Full display or unclear display during operation indicates the batteries have been used up. Please change batteries.

If the remote controller can’t run normally during operation, please remove the batteries and reload several minutes later.

Hint:

Remove the batteries in case unit won’t be in usage for a long period. If there are any display after taking-out, just need to press reset key.

2