Briggs & Stratton 074002 operating instructions Storage, Inspect Spark Plug, Inspect Safety Labels

Page 20

MAINTENANCE / STORAGE

Inspect Spark Plug

Change the spark plug every 100 hours of operation or once each year, whichever comes first.This will help your engine to start easier and run better.

1.Clean area around spark plug.

2.Remove and inspect spark plug.

3.Inspect electrode gap with wire feeler gauge and set spark plug gap to 0.030 inch (0.76mm) if necessary (see Figure 21).

Figure 21 — Spark Plug

4.Replace spark plug if electrodes are pitted, burned, or if porcelain is cracked. Use the recommended replacement spark plug (see Page 13).

5.Install spark plug and tighten firmly.

Inspect Safety Labels

As often as desired or at least yearly, inspect all labels applied to the air compressor. All safety labels should be present and readable. If any safety label is missing or illegible, obtain a replacement from an authorized service center or call the air compressor helpline at 1-800-743-4115.

STORAGE

The air compressor should be started at least once every seven days and allowed to run at least 30 minutes. If this cannot be done and you must store the unit for more than

30 days, use the following information as a guide to prepare it for storage.

Before you store your air compressor, make sure you perform the following:

1.Review MAINTENANCE beginning on page 14 and perform scheduled maintenance as necessary.

2.Turn engine ON/OFF switch to OFF position (see Figure 9 earlier).

3.Move Fuel Shutoff Valve lever to OFF position (see Figure 8 earlier).

4.Turn Pressure Control knob counterclockwise until knob turns freely.

5.Remove air hose(s), air tool(s), or accessories.

6.Pull ring on Safety Valve and drain air from air tanks to reduce air pressure. Release Safety Valve ring.

7.Drain remaining air and water condensate from tanks by opening Drain Valves fully counterclockwise.

8.Rock unit gently side to side or forward and back to agitate condensate as it drains to obtain a more thorough emptying action.

9.After condensate has been drained, close Drain Valves fully clockwise.

10.Protect air hose(s) from damage (such as being stepped on or driven over).

Long Term Storage Instructions

It is important to prevent gum deposits from forming in essential fuel system parts, such as the carburetor, fuel filter, fuel hose or tanks during storage. Also, experience indicates that alcohol-blended fuels (called gasohol, ethanol or methanol) can attract moisture, which leads to separation and formation of acids during storage. Acidic fuel can damage the fuel system of an engine while in storage.

Fuel Additive:

If using a fuel additive, fill the Fuel Tank with fresh fuel. If only partially filled, air in the Fuel Tank will promote fuel deterioration during storage. Engine and fuel can be stored up to 24 months with additive.

• Add fuel additive following manufacturer’s instructions.

20

Image 20
Contents 074002 Call Helpline Appelez Ligne dassistance Llame Línea DirectaEquipment Description Table of ContentsSafety Rules Hazard Symbols and Meanings Safety RulesSafety Rules When Adjusting or Making Repairs to Your AIR Compressor When Testing for Engine SparkWhen Adding or Draining Fuel When Starting EquipmentAssembly Carton ContentsUnpacking Verify Engine and Pump Oil LevelsInstall Pump Oil Breather Cap Fuel Level IndicatorDrain Valve shown in Open position Oil Fill LocationFeatures and Controls Features and ControlsCompressor Oil Fill Location Fill pump with oil here.Oil Quick Connect Fittings Connect air hoses hereBreak-In Procedure OperationAir Compressor Operating Location OperationStarting Your Air Compressor Start valve is shown in Closed positionUse the handles to lift or carry the unit Stopping Your Air CompressorTransport Compressor Operation Pressure ControlSpecifications Power RatingsSpecifications Product SpecificationsMaintenance MaintenanceMaintenance Service Dates Service Intervals Maintenance TaskMaintenance Cleaning UnitGeneral Recommendations Emissions ControlInspect Safety Valve Inspect Quick Connect Fittings and Tank Drain ValvesInspect Engine Oil Level Oil RecommendationsInspect Engine Air Cleaner To service the air cleaner, follow these stepsInspect Pump Oil Level Changing Engine OilOil Fill Opening Clean Spark Arrester ScreenCalling Changing Pump Oil Inspect / Clean Pump Air FilterFilter Housing Inspect Safety Labels Maintenance / StorageStorage Inspect Spark PlugWhen Draining Fuel Other Storage TipsStorage Change OilBefore You Call TroubleshootingTroubleshooting Operate accessories Lacks power startsCompressor is not Supplying enough air toGlossary GlossaryEmissions Emissions Control System Warranty Owner’s Warranty ResponsibilitiesWarranty Period Limited WarrantyTable DES Matières Description DE L’ÉQUIPEMENTRègles DE Sécurité AvertissementSymboles de risque et leur signification Règles DE SécuritéChoc électrique Explosion Objets volants SurfaceAvertissement Mise EN Garde Lors DE Tests D’ALLUMAGE DU MoteurAssemblage AssemblageInstallez le bouchon reniflard de la pompe à lhuile Fonctions ET Commandes Fonctions ET CommandesEmplacement du compresseur d’air lors de l’utilisation FonctionnementFonctionnement Procédure de rodageDémarrage de votre compresseur d’air Tournez l’interrupteur ON/OFF du moteur à la position OFFSuivez les directives de démarrage suivantes Le levier d’étrangleur est illustré à la position ChokeFermez les robinets de vidange Arrêt de votre compresseur d’airTransport Pression Utilisation du compresseurManomètre de pression Bouton de De sortie Spécifications CaractéristiquesPuissance nominale Caractéristiques du produitEntretien EntretienRecommandations générales Contrôle des émissionsEntretien Nettoyage de l’unitéRecommandations relatives à l’huile Vérifiez la soupape de sûretéVérifiez le niveau d’huile du moteur Vérification du niveau d’huile du moteurVérifiez le niveau d’huile de la pompe Vérifiez le filtre à air du moteurVidange de l’huile moteur Vérification du niveau d’huile de la pompeUtilisez un entonnoir et videz lentement de l’huile environ Nettoyage de l’écran pare-étincellesBouchon de vidange d’huile Orifice de Vérifiez/nettoyez le filtre à air de la pompe Changement d’huile de la pompeFiltre à air CompresseurEntreposage Entretien / EntreposageVérification de la bougie Vérifiez les étiquettes de sécuritéEntreposage Autres conseils d’entreposageChangement de l’huile Huilage de l’alésage du cylindreProblème Cause Solution DépannageDépannage Avant de nous contacterAccessoires Le compresseur ne fournitPas suffisamment d’air pour Le fonctionnement des Le moteur ne démarre pasGlossaire GlossaireÉmissions Garantie DU Dispositif Antipollution Période DE Garantie Garantie LimitéeTabla DE Contenido Descripción DEL EquipoNormas DE Seguridad AdvertenciaNormas DE Seguridad Símbolos de peligro y sus significadosAire ExplosiónAdvertencia Precaución Cuando Ajuste O Repare EL Compresor DE AireMontaje MontajeInstalación del tapón del respirador del aceite de la bomba Tapón del respiradorDel aceite Punto de llenadoCaracterísticas Y Mandos Características Y MandosDel motor Estranguladora Filtro de aire Válvula delFuncionamiento FuncionamientoColocación del compresor de aire Procedimiento de preparación para el uso inicialPuesta en marcha del compresor de aire AbiertaDespués de que el compresor de aire funcione durante Palanca en la posiciónParada del compresor de aire TransporteMueva la palanca estranguladora hacia la posición FuncionamientoUso del compresor Figura 56 Control de presiónEspecificaciones EspecificacionesPotencia nominal Especificaciones del productoMantenimiento MantenimientoRecomendaciones generales Control de emisionesMantenimiento Limpieza de la unidadInspeccione la válvula de seguridad Inspeccione el nivel de aceite del motorRecomendaciones sobre el aceite Inspección del nivel de aceite del motorInspeccione el nivel de la bomba de aceite Inspeccione el filtro de aire del motorCambio del aceite del motor Inspección del nivel de la bomba de aceiteLimpieza de la pantalla apagachispas Tapón de vaciado de aceiteInspeccione/limpie el filtro de aire de la bomba Cambio del aceite de la bombaAlmacenamiento MANTENIMIENTO/ALMACENAMIENTORevisión de la bujía Inspección de las etiquetas de seguridadAlmacenamiento Otras sugerencias para el almacenamientoCambio de aceite Aceite en el interior del cilindroResolución DE Problemas Resolución DE ProblemasProblema Motivo Corrección Antes de llamarOFF Glosario GlosarioNotas Emisiones Garantía DEL Sistema DE Control DE Emisiones Período DE Garantía Garantía Limitada