Briggs & Stratton 074002 Emissions Control System Warranty, Owner’s Warranty Responsibilities

Page 26

EMISSIONS CONTROL SYSTEM WARRANTY

Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB)

and the United States Environmental Protection Agency (U.S. EPA)

Emissions Control System Warranty Statement

(Owner’s Defect Warranty Rights and Obligations)

California, United States and Canada Emissions Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and B&S are pleased to explain the Emissions Control System Warranty on your small off–road engine (SORE). In California, new small off–road engines model year 2006 and later must be designed, built and equipped to meet the State’s stringent anti–smog standards. Elsewhere in the United States, new non–road, spark–ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. B&S must warrant the emissions control system on your engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off–road engine.

Your emissions control system includes parts such as the carburetor, air cleaner, ignition system, fuel line, muffler and catalytic converter. Also included may be connectors and other emissions related assemblies.

Where a warrantable condition exists, B&S will repair your small off–road engine at no cost to you including diagnosis, parts and labor.

Briggs & Stratton Emissions Control Defects Warranty Coverage

Small off–road engines are warranted relative to emissions control parts defects for a period of two years, subject to provisions set forth below. If any covered part on your engine is defective, the part will be repaired or replaced by B&S.

Owner’s Warranty Responsibilities

As the small off–road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instructions. B&S recommends that you retain all your receipts covering maintenance on your small off–road engine, but B&S cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off–road engine owner, you should however be aware that B&S may deny you warranty coverage if your small off–road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off–road engine to an Authorized B&S Service Dealer as soon as a problem exists.The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a B&S Service Representative at 1–414–259–5262.

The emissions warranty is a defects warranty. Defects are judged on normal engine performance.The warranty is not related to an in–use emissions test.

Briggs & Stratton Emissions Control Defects Warranty Provisions

The following are specific provisions relative to your Emissions Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non–regulated engines found in the Owner’s Manual.

1.Warranted Parts

Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased.

a.Fuel Metering System

Cold start enrichment system (soft choke)

Carburetor and internal parts

Fuel Pump

Fuel line, fuel line fittings, clamps

b.Air Induction System

• Air cleaner

• Intake manifold

c.Ignition System

Spark plug(s)

Magneto ignition system

d.Catalyst System

Catalytic converter

Exhaust manifold

Air injection system or pulse valve

e.Miscellaneous Items Used in Above Systems

Vacuum, temperature, position, time sensitive valves and switches

Connectors and assemblies

2.Length of Coverage

B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the failure of the Warranted Parts for a period of two years from the date the engine is delivered to a retail purchaser.

3.No Charge

Repair or replacement of any Warranted Part will be performed at no charge to the owner, including diagnostic labor which leads to the determination that a Warranted Part is defective, if the diagnostic work is performed at an Authorized B&S Service Dealer. For emissions warranty service contact your nearest Authorized B&S Service Dealer as listed in the “Yellow Pages” under “Engines, Gasoline,” “Gasoline Engines,” “Lawn Mowers,” or similar category.

4.Claims and Coverage Exclusions

Warranty claims shall be filed in accordance with the provisions of the B&S Engine Warranty Policy.Warranty coverage shall be excluded for failures of Warranted Parts which are not original B&S parts or because of abuse, neglect or improper maintenance as set forth in the B&S Engine Warranty Policy. B&S is not liable to cover failures of Warranted Parts caused by the use of add–on, non–original, or modified parts.

5.Maintenance

Any Warranted Part which is not scheduled for replacement as required maintenance or which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall be warranted as to defects for the warranty period. Any Warranted Part which is scheduled for replacement as required maintenance shall be warranted as to defects only for the period of time up to the first scheduled replacement for that part. Any replacement part that is equivalent in performance and durability may be used in the performance of any maintenance or repairs. The owner is responsible for the performance of all required maintenance, as defined in the B&S Owner’s Manual.

6.Consequential Coverage

Coverage hereunder shall extend to the failure of any engine components caused by the failure of any Warranted Part still under warranty.

Image 26
Contents 074002 Call Helpline Appelez Ligne dassistance Llame Línea DirectaEquipment Description Table of ContentsSafety Rules Hazard Symbols and Meanings Safety RulesSafety Rules When Adding or Draining Fuel When Adjusting or Making Repairs to Your AIR CompressorWhen Testing for Engine Spark When Starting EquipmentUnpacking AssemblyCarton Contents Verify Engine and Pump Oil LevelsDrain Valve shown in Open position Install Pump Oil Breather CapFuel Level Indicator Oil Fill LocationCompressor Oil Fill Location Fill pump with oil here.Oil Features and ControlsFeatures and Controls Quick Connect Fittings Connect air hoses hereAir Compressor Operating Location Break-In ProcedureOperation OperationStarting Your Air Compressor Start valve is shown in Closed positionUse the handles to lift or carry the unit Stopping Your Air CompressorTransport Compressor Operation Pressure ControlSpecifications SpecificationsPower Ratings Product SpecificationsMaintenance Service Dates Service Intervals MaintenanceMaintenance Maintenance TaskGeneral Recommendations MaintenanceCleaning Unit Emissions ControlInspect Engine Oil Level Inspect Safety ValveInspect Quick Connect Fittings and Tank Drain Valves Oil RecommendationsInspect Pump Oil Level Inspect Engine Air CleanerTo service the air cleaner, follow these steps Changing Engine OilOil Fill Opening Clean Spark Arrester ScreenCalling Changing Pump Oil Inspect / Clean Pump Air FilterFilter Housing Storage Inspect Safety LabelsMaintenance / Storage Inspect Spark PlugStorage When Draining FuelOther Storage Tips Change OilBefore You Call TroubleshootingTroubleshooting Compressor is not Operate accessoriesLacks power starts Supplying enough air toGlossary GlossaryEmissions Emissions Control System Warranty Owner’s Warranty ResponsibilitiesWarranty Period Limited WarrantyRègles DE Sécurité Table DES MatièresDescription DE L’ÉQUIPEMENT AvertissementChoc électrique Explosion Symboles de risque et leur significationRègles DE Sécurité Objets volants SurfaceAvertissement Mise EN Garde Lors DE Tests D’ALLUMAGE DU MoteurAssemblage AssemblageInstallez le bouchon reniflard de la pompe à lhuile Fonctions ET Commandes Fonctions ET CommandesFonctionnement Emplacement du compresseur d’air lors de l’utilisationFonctionnement Procédure de rodageSuivez les directives de démarrage suivantes Démarrage de votre compresseur d’airTournez l’interrupteur ON/OFF du moteur à la position OFF Le levier d’étrangleur est illustré à la position ChokeFermez les robinets de vidange Arrêt de votre compresseur d’airTransport Pression Utilisation du compresseurManomètre de pression Bouton de De sortie Puissance nominale SpécificationsCaractéristiques Caractéristiques du produitEntretien EntretienEntretien Recommandations généralesContrôle des émissions Nettoyage de l’unitéVérifiez le niveau d’huile du moteur Recommandations relatives à l’huileVérifiez la soupape de sûreté Vérification du niveau d’huile du moteurVidange de l’huile moteur Vérifiez le niveau d’huile de la pompeVérifiez le filtre à air du moteur Vérification du niveau d’huile de la pompeUtilisez un entonnoir et videz lentement de l’huile environ Nettoyage de l’écran pare-étincellesBouchon de vidange d’huile Orifice de Filtre à air Vérifiez/nettoyez le filtre à air de la pompeChangement d’huile de la pompe CompresseurVérification de la bougie EntreposageEntretien / Entreposage Vérifiez les étiquettes de sécuritéChangement de l’huile EntreposageAutres conseils d’entreposage Huilage de l’alésage du cylindreDépannage Problème Cause SolutionDépannage Avant de nous contacterPas suffisamment d’air pour Le fonctionnement des AccessoiresLe compresseur ne fournit Le moteur ne démarre pasGlossaire GlossaireÉmissions Garantie DU Dispositif Antipollution Période DE Garantie Garantie LimitéeNormas DE Seguridad Tabla DE ContenidoDescripción DEL Equipo AdvertenciaAire Normas DE SeguridadSímbolos de peligro y sus significados ExplosiónAdvertencia Precaución Cuando Ajuste O Repare EL Compresor DE AireMontaje MontajeDel aceite Instalación del tapón del respirador del aceite de la bombaTapón del respirador Punto de llenadoDel motor Estranguladora Filtro de aire Características Y MandosCaracterísticas Y Mandos Válvula delColocación del compresor de aire FuncionamientoFuncionamiento Procedimiento de preparación para el uso inicialDespués de que el compresor de aire funcione durante Puesta en marcha del compresor de aireAbierta Palanca en la posiciónMueva la palanca estranguladora hacia la posición Parada del compresor de aireTransporte FuncionamientoUso del compresor Figura 56 Control de presiónPotencia nominal EspecificacionesEspecificaciones Especificaciones del productoMantenimiento MantenimientoMantenimiento Recomendaciones generalesControl de emisiones Limpieza de la unidadRecomendaciones sobre el aceite Inspeccione la válvula de seguridadInspeccione el nivel de aceite del motor Inspección del nivel de aceite del motorCambio del aceite del motor Inspeccione el nivel de la bomba de aceiteInspeccione el filtro de aire del motor Inspección del nivel de la bomba de aceiteLimpieza de la pantalla apagachispas Tapón de vaciado de aceiteInspeccione/limpie el filtro de aire de la bomba Cambio del aceite de la bombaRevisión de la bujía AlmacenamientoMANTENIMIENTO/ALMACENAMIENTO Inspección de las etiquetas de seguridadCambio de aceite AlmacenamientoOtras sugerencias para el almacenamiento Aceite en el interior del cilindroProblema Motivo Corrección Resolución DE ProblemasResolución DE Problemas Antes de llamarOFF Glosario GlosarioNotas Emisiones Garantía DEL Sistema DE Control DE Emisiones Período DE Garantía Garantía Limitada