Sparky Group GUR 12S manual VII Know your product, Viii Operation, Switch Operation















Figure 3

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

:KHQXVLQJ\RXUFRUGOHVVDQJOHGULOOGULYHUFRQ- tinuously, the batteries in your battery pack will become hot. You should let a hot battery pack FRRO GRZQ IRU DSSUR[LPDWHO\  PLQXWHV EHIRUH attempting to recharge. When the battery pack becomes discharged and is hot, the red light on WKHFKDUJHUZLOOÀDVK:KHQWKHEDWWHU\SDFNFRROV down, the red light will glow continuously to indi- cate fast charging mode, 1-hour charge time.

NOTE. This will occur when continuous use of your tool causes the battery pack to become hot. It does not occur under normal conditions.

VII - Know your product

212))VZLWFK

)RUZDUGUHYHUVHVZLWFK $QYLO

4.Socket

%DWWHU\

&KDUJHU

/('FKDUJHLQGLFDWRU

VIII - Operation

SWITCH OPERATION

7R WXUQ WKH PDFKLQH RQ VTXHH]H WKH WULJJHU switch. To turn the machine off, release the trig- ger switch.

2.Your power tool is equipped with a brake. The tool will stop as soon as the trigger switch is fully

UHOHDVHG7KHIDUWKHU\RXVTXHH]HWKHWULJJHU the faster the tool will operate.

INSTALLING / REMOVING

THE IMPACT SOCKET

1.Align the hole in the side of the socket; put it

RQWRWKHDQYLORIWKHWRROXQWLOLWORFNVLQWRSODFH Fig. 4

2.Depress the detent pin through the hole, and pull the socket off.

7R UHPRYH WKH ELW  VRFNHW SHUIRUP WKH DERYH PHQWLRQHGLQUHYHUVHRUGHU

CAUTION: When using the hex adapter and any of the hex bits supplied with WKHPDFKLQHLIWKHJXLGHVOHHYHGRHVQRWUHWXUQ to its original position, then the bit is not installed properly.

CAUTION: Always set the switch to off

SRVLWLRQZKHQLQVHUWLQJRUUHPRYLQJELWV

Figure 4

FORWARD / REVERSE SWITCH

7KHELWURWDWHVFORFNZLVHYLHZHGIURPWKHUHDU by pushing the R-side of the push button. The /VLGHRIWKHSXVKEXWWRQLVSXVKHGWRWXUQWKHELW FRXQWHUFORFNZLVHFig. 5

CAUTION: The push button can not be switched while the drill is turning. To switch the push button, stop the machine and then set the push button.

Figure 5