Hitachi hitachi series inverter A092, A292, A093, A293, A094, A294, A095, A295, A096, A296, A097

				Run
	Func.	Name	Description	Mode	Initialdata		Units
	Code			Edit
A092		Acceleration time (2)	Duration of 2nd segment of		10.00		sec
			acceleration, range is:
		Acceleration time (2),	0.01 to 3600 sec.
A292					10.00		sec
		2nd motor
A093		Deceleration time (2)	Duration of 2nd segment of		10.00		sec
			deceleration, range is:
		Deceleration time (2),	0.01 to 3600 sec.		10.00		sec
A293
		2nd motor
A094		Select method to switch to	Three options for switching from		00		−
		Acc2/Dec2 profile	1st to 2nd accel/decel:
A294		Select method to switch to	00…2CH input from terminal		00		−
			01…Transition frequency
		Acc2/Dec2 profile, 2nd motor
			02…Forward and reverse
A095		Acc1 to Acc2 frequency	Output frequency at which		0.0		Hz
		transition point	Accel1 switches to Accel2, range
		Acc1 to Acc2 frequency	is 0.0 to 400.0 Hz		0.0		Hz
A295
		transition point, 2nd motor
A096		Dec1 to Dec2 frequency	Output frequency at which		0.0		Hz
		transition point	Decel1 switches to Decel2,
		Dec1 to Dec2 frequency	range is 0.0 to 400.0 Hz		0.0		Hz
A296
		transition point, 2nd motor
A097		Acceleration curve selection	Set the characteristic curve of		01		−
			Acc1 and Acc2, five options:
			00…linear
			01…S-curve
			02…U-curve
			03…Inverse U-curve
			04…EL S-curve
A098		Deceleration curve selection	Set the characteristic curve of		01		−
			Dec1 and Dec2, options are
			same as above (a097)
A101		[OI] input active range start	The output frequency		0.00		Hz
		frequency	corresponding to the analog
			input range starting point,
			range is 0.0 to 400.0 Hz
A102		[OI] input active range end	The output frequency		0.0		Hz
		frequency	corresponding to the current
			input range ending point,
			range is 0.0 to 400.0 Hz
A103		[OI] input active range start	The starting point (offset) for the		20.	%
		current	current input range,
			range is 0. to 100.%
A104		[OI] input active range end	The ending point (offset) for the		100.	%
		current	current input range,
			range is 0. to 100.%
A105		[OI] input start frequency	Two options; select codes:		00		−
		select	00…Use offset (A101 value)
			01…Use 0Hz

55