Hitachi hitachi series inverter C028, C030, C031, C032, C036, C038, C039, C040, C041, C241, C042

					Run
	Func.	Name		Description	Mode		Initialdata		Units
	Code				Edit
C028		[AM] terminal selection		11 programmable functions:		07			−
		(Analog voltage output		00…			[LAD]
		0...10V)		Output frequency
				01…Output current
				02…Output torque
				04…Output voltage
				05…Input power
				06…Electronic thermal load ratio
				07…LAD frequency
				10…Heat sink temperature
				11…Output torque (with code)
				13…General output
				16…Option
C030		Digital current monitor		Current with digital current monitor		Rated current			A
		reference value		output at 1,440Hz
				Range is 20%~200% of rated
				current
C031		Output [11] active state		Select logic conversion, two option		00			−
				codes:
C032		Output [12] active state				00		-
				00…normally open [NO]
C036		Alarm relay active state				01			−
				01…normally closed [NC]
C038		Output mode of low current		Two option codes:		01			−
		detection		00…During acceleration,
				deceleration and constant speed
				01…During constant speed only
C039		Low current detection level	Set the level of low load detection,				INV rated		A
				range is 0.0 to 2.0*inverter rated			current
				current
C040		Output mode of overload		Two option codes:		01			−
		warning	00…During accel., decel. and
			constant speed
				01…During constant speed only
C041		Overload warning level	Sets the overload warning signal				Rated current		A
				level between 0% and 200% (from			x 1.15
				0 to two time the rated current of
		Overload warning level, 2nd		the inverter)
C241				Sets the overload warning signal			Rated current		A
		motor		level between 0% and 200% (from			x 1.15
				0 to two time the rated current of
				the inverter)
C042		Frequency arrival setting		Sets the frequency arrival setting		0.0			Hz
		for acceleration		threshold for the output frequency
				during acceleration,
				range is 0.0 to 400.0 Hz
C043		Frequency arrival setting		Sets the frequency arrival setting		0.0			Hz
		for deceleration		threshold for the output frequency
				during deceleration,
				range is 0.0 to 400.0 Hz
C044		PID deviation level	Sets the allowable PID loop error			3.0		%
				magnitude (absolute value),
				SP-PV, range is 0.0 to 100%
C045		Frequency arrival setting 2		Set range is 0.0 to 400.0 Hz		0.00			Hz
		for acceleration
C046		Frequency arrival setting 2		Set range is 0.0 to 400.0 Hz		0.00			Hz
		for deceleration

67