Abrasive Type 1 & 27 Cutting
Wheel Assembly
Always use type 1 cutting
guard for cutting operations. Other guards or attachments may not protect operator in the event of a wheel burst.
A type 27 wheel guard may ! WARNING not be used for all tool
operations. Do not discard guard when not in use. Always reinstall wheel guard when converting back to grinding operations.
To install cutting wheel (Fig. 9):
1.Unplug tool from power source.
2.Install and adjust type 1 cutting guard to the proper position for cutting as shown in figure 5.
3.Place the backing flange on the spindle. Turn flange until it locks with the base of the spindle.
4.Place the cutting wheel onto the spindle and align the arbor hole of the cutting wheel with the shoulder of the backing flange.
5.Thread the lock nut onto the spindle with the lock nut relief facing the accessory.
6.Tighten lock nut with supplied lock nut wrench while holding spindle lock.
TO REMOVE: Reverse procedure.
FIG. 9
SPINDLE
TYPE 1
WHEEL GUARD
BACKING
FLANGE
| LOCK NUT |
TYPE 1A | TYPE 27A |
CUTTING | CUTTING |
WHEEL | WHEEL |
TYPE 27A | SPINDLE |
CUTTING |
|
WHEEL | BACKING |
| |
| FLANGE |
| LOCK NUT |