Concrete Dust Extraction
Attachment for Surfacing Grinding
Assembly
A type 27 grinding wheel ! WARNING guard may not be used for
all tool operations. Do not discard guard when not in use. Always reinstall wheel guard when converting back to grinding operations.
| Dust | Extraction |
! WARNING | ||
| Attachment | is not a guard, |
|
do not use with bonded abrasive wheels. Dust extraction attachment may not protect operator in the event of a wheel burst.
To install concrete dust extraction attachment (Fig. 10):
1.Unplug tool from power source.
2.Position appropriate attachment on spindle neck with dust port pointing away from tool body.
3.Rotate attachment clockwise 90º until guard clicks in place.
4.Adjust attachment by depressing guard release button and rotate to desired position.
5.Allow guard release button to click in place.
6.Place the backing flange on the spindle.
7.Place the diamond cup wheel onto the spindle and align with the flange.
8.Thread the lock nut onto the spindle with the lock nut relief facing the accessory.
9.Tighten lock nut with supplied lock nut wrench while holding spindle lock.
When using spin on wheels, follow steps 1 - 5, then thread wheel directly onto spindle without using the supplied flanges.
TO REMOVE: Reverse procedure.
FIG. 10
SPINDLE
CONCRETE DUST EXTRACTION
ATTACHMENT
WHEEL SPINDLE
GUARD NECK