6.Screw in side handle to secure stability bracket between the tool housing and handle.
7.Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
Installing dry diamond wheel (Fig. 15):
1.Place the backing flange on the spindle. Turn flange until it locks with the base of the spindle.
2.Place the dry diamond wheel onto the spindle and align the arbor hole of the grinding wheel with the shoulder of the backing flange.
3.Tighten lock nut with supplied lock nut wrench while holding spindle lock.
TO REMOVE: Reverse procedure.
BACKING
FLANGE
DRY
DIAMOND
WHEEL
FIG. 15
SPINDLE
DRY
DIAMOND
WHEEL
LOCK
NUT
SPINDLE
BACKING
FLANGE
LOCK NUT
Wire Wheel Assembly
To install wire wheel (Fig. 16):
1.Unplug tool from power source.
2.Install and adjust type 27 grinding guard to the proper position as shown in figure 5.
3.Thread wire wheel onto spindle until secure.
NOTE: Be sure to seat wire wheel against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
FIG. 16
SPINDLE
TYPE 27
WHEEL GUARD
WIRE WHEEL