Output is curled or wrinkled
You are printing large,
Large,
Media used was not stored correctly and | Remove media and replace it with media from |
may have absorbed moisture. | a fresh, unopened package. |
|
|
Media has poorly cut edges. | Remove media, flex it, rotate it 180 degrees or |
| turn it over, and then reload it into the input |
| tray. Do not fan media. If the problem persists, |
| replace the media. |
The specific media type was not configured for the tray or selected in the software.
Configure the software for the media (see the software documentation). Configure the tray for the media, see Configuring input trays.
Printer will not duplex or duplexes incorrectly
Cause | Solution |
You are trying to duplex on unsupported media.
Verify that the media is supported for duplex printing. See Supported media weights and sizes.
The printer driver is not set up for duplex | Set up the printer driver to enable duplex |
printing. | printing. |
|
|
The first page is printing on the back of | Load preprinted forms and letterhead in Tray 1 |
preprinted forms or letterhead. | with the letterhead or printed side up and the |
| bottom of the page feeding into the printer. |
| For Tray 2 or Tray 3, load these media printed |
| side down with the top of the page toward the |
| back of the printer. |
|
|
176 | ENWW |