Setting the subnet mask
| 1. | Press ✔ to enter the MENUS. | |||
| 2. | Press | to highlight CONFIGURE DEVICE. | ||
| 3. | Press ✔ to select CONFIGURE DEVICE. | |||
| 4. | Press | to highlight I/O. | ||
| 5. | Press ✔ to select I/O. | |||
| 6. | Press | to highlight EIO X (where X = 1, 2, or 3). | ||
| 7. | Press ✔ to select EIO X. | |||
| 8. | Press | to highlight MANUAL. | ||
| 9. | Press ✔ to select MANUAL. | |||
| 10. | Press | to highlight SUBNET MASK. | ||
| 11. | Press ✔ to select SUBNET MASK. | |||
|
| ||||
Note | The first of three sets of numbers is highlighted. If there is not a number | ||||
| highlighted, a highlighted empty underscore appears. | ||||
| 12. | Press the | or | arrow to to increase or decrease the number | |
| |||||
|
| for configuring the subnet mask. |
13.Press ✔ to move to the next set of numbers.
14.Repeat steps 12 and 13 until the correct subnet mask is entered.
15.Press the PAUSE/RESUME button to return to the READY state.
Setting the local and default gateway
1. | Press ✔ to enter the MENUS. | |
2. | Press | to highlight CONFIGURE DEVICE. |
3.Press ✔ to select CONFIGURE DEVICE.
4. | Press | to highlight I/O. |
5. | Press | ✔ to select I/O. |
6. | Press | to highlight EIO X (where X = 1, 2, or 3). |
7. | Press | ✔ to select EIO X. |
8. | Press | to highlight MANUAL. |
9. | Press | ✔ to select MANUAL. |
10. Press | to highlight LOCAL GATEWAY or DEFAULT GATEWAY. | |
11. Press | ✔ to select LOCAL GATEWAY or DEFAULT GATEWAY. |
50 | ENWW |