3.Press ✔ to select CONFIGURE DEVICE.
4. | Press | to highlight I/O. |
5. | Press ✔ to select I/O. | |
6. | Press | to highlight EIO X (where X = 1, 2, or 3). |
7. | Press ✔ to select EIO X. | |
8. | Press | to highlight AUTO. |
9.Press ✔ to select AUTO.
10.Press the PAUSE/RESUME button to return to the READY state.
To manually configure TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, and local and default gateway.
Setting an IP address
| 1. | Press ✔ to enter the MENUS. | |||
| 2. | Press | to highlight CONFIGURE DEVICE. | ||
| 3. | Press ✔ to select CONFIGURE DEVICE. | |||
| 4. | Press | to highlight I/O. | ||
| 5. | Press ✔ to select I/O. | |||
| 6. | Press | to highlight EIO X (where X = 1, 2, or 3). | ||
| 7. | Press ✔ to select EIO X. | |||
| 8. | Press | to highlight MANUAL. | ||
| 9. | Press ✔ to select MANUAL. | |||
| 10. | Press | to highlight IP ADDRESS. | ||
| 11. | Press ✔ to select IP ADDRESS. | |||
|
| ||||
Note | The first of three sets of numbers is highlighted. If there is not a number | ||||
| highlighted, a highlighted empty underscore appears. | ||||
| 12. | Press the | or | arrow to to increase or decrease the number | |
| |||||
|
| for configuring the IP address. |
13.Press ✔ to move to the next set of numbers.
14.Repeat steps 12 and 13 until the correct IP address is entered.
15.Press the PAUSE/RESUME button to return to the READY state.
ENWW | 49 |