❉ | Power Connection — Permanent Wiring Option |
|
If required by local codes, the opener can be permanently wired. Services of a licensed electrician should be obtained, to permanently wire the Unit. Disconnect electrical power at fuse/breaker box.
WARNING
TO AVOID ELECTRICAL SHOCK, DISCONNECT POWER AT FUSE/ BREAKER BOX BEFORE PROCEEDING.
a. Using a phillips head screwdriver, remove the two screws from the right hand cover and unplug motor power cable. Remove right hand cover from the opener to expose electronics and wiring.
b. Remove potentiometer gear. Unsnap the circuit board from the chassis
NOTE: Do not disconnect the two ground wires (A & B) from the circuit board or the chassis.
c. Using pliers, compress 3 snaps of the strain relief fitting inside the chassis and push fitting out of the chassis. Cut opener power cord to a length that will leave 6” inside of the junction box.
d. Route opener power cable through the conduit. Strip 2 to 3 inches of outer jacket off power cable, insuring individual wire insulation is not nicked or cut. Strip approximately 3/4” of insulation off each individual wire. Using wire nuts, splice each conduit wire with the corresponding wire inside the opener as follows: opener black (line), opener white (neutral), and opener yellow and green (ground).
NOTE: Select 1/2” conduit fitting/
e. Reinstall the circuit board back into the opener chassis and snap the board back into the chassis
NOTE: Make sure antenna wire is routed through the chassis grommet and angled 45 degrees to right when board is installed.
f.Confirm pot nut position* shown below.
g.Reinstall the potentiometer gear, right hand cover, and screws.
h.Reconnect Power
Potentiometer Gear
| Junction |
Antenna | Box |
|
Grommet
Green and Yellow | Strain | |
Relief Fitting | ||
(Ground) | ||
Chassis | ||
| Standoff |
“A”
“B”
Black 
(Line)
White
(Neutral)
*Potentiometer
Gear Clip
1/8” – 3/16” *Position Pot Nut
Gap 1/8” - 3/16” Away from Left Stop
No Interference
Between Conduit
And Disconnect
View Of Right Hand Side
39Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at