❉Station(s) or Transmitter(s) to OpenerProgramming Wireless Wall
Tools Needed: | WARNING |
|
|
| |
None |
|
|
TO AVOID POSSIBLE SEVERE OR FATAL | ||
| INJURY, MANUALLY DISCONNECT THE | |
| OPENER, USING THE EMERGENCY | |
| DISCONNECT HANDLE PRIOR TO | |
| PROGRAMMING REMOTE CONTROLS. | |
NOTE: The opener can be activated by up to six remote control devices (including Wall Station, Transmitter, and Keyless Entry Devices). If a seventh control is programmed, the first of the program controls will be overwritten and will no longer activate the opener.
Handle In Manual
Door Operated
Position
Motor in
Up Position
Red Program
Button
a. Pull the emergency disconnect handle to the manual door operated position (lower position).
b. On the front cover of the opener, press and release the red program button; the opener will beep once, indicating activation of the program mode. The opener will remain in program mode for 30 seconds. If at the end of 30 seconds the opener has not learned an RF device, the opener will beep once, indicating the learn mode is no longer active.
c. Press and hold the desired transmitter button or wall station light button until the opener beeps once. The transmitter of wall station is now programmed.
No beeping response from the opener during the transmitter or wall station programming indicates a programming failure. Repeat programming Steps
d. Return the emergency disconnect handle to the motor operated position (upper position).
NOTE: The first transmitter command after programming will only move the door through a six inch up/down cycle. Normal door operations will occur on the second use of the transmitter or wall station.
a |
| b |
|
|
|
|
|
c |
|
|
|
|
|
|
|
Light Button
Large Button
| per | |
| O | at |
LED | o |
|
T | D | |
Presso
o
Here r
d
Handle In Motor
Operated
Position
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need. 40 You can reach us Toll Free at