Conair GB/ WSB manual Part Assembly, Load Cells are Easily Damaged, Please Be Careful, On the Next

+--------------------------------------------------------------------		Page 5	+
¦	PART I	- ASSEMBLY	¦
+--------------------------------------------------------------------			+
ASSEMBLY	and INSTALLATION INSTRUCTIONS
CAUTION:	LOAD CELLS ARE EASILY DAMAGED.
If the FRAME is dropped from TWO		FEET, the load cells WILL be DAMAGED.
	PLEASE,	BE CAREFUL.

The following items have been shipped to you:

1.FRAME, fully assembled: (bolted to pallet)

2.CONTROLLER: the controller and the instruction manual.

3.FEEDERS: optional COLOR or ADDITIVE feeders as ordered.

4.FLOW CONTROL ASSEMBLY: optional

5.FLOOR STAND or VACUUM TAKEOFF ASSEMBLY: optional

RED INSTRUCTION STICKERS will assist you during assembly.

LIFT HANGERS are available to allow lifting of the blender with a strap or chain. Call us if you require them.

1A. If your	unit	is	to be MACHINE mounted:
For GB/WSB		100, 200, and 400 series		models:
Two	ways	to	do this are suggested	ON THE NEXT PAGE.

The LEFT diagram shows the FRAME and SLIDE GATE both drilled with the proper bolt pattern for your machine and THROUGH- BOLTED to your press.

The RIGHT diagram shows only the 10 x 10 steel slide-gate plate drilled for your bolt pattern and bolted to your press. The FRAME is then bolted to it using the 8 x 8 inch bolt pattern holes and bolts provided. With this method, bolt head clearance holes are required in the poly-pro slide gate plate. This mounting works well on smaller machines.

For GB/WSB 900 and 1800 series models:

An additional machine mount adaptor plate may be required. If you have ANY DOUBT about the STABILITY of the unit when bolted directly to your machine throat, please call us for advice.

NOTE: When choosing proper orientation, be sure you have access to the controller and weigh chamber, clearance for hinged doors, and access to removable feeder hoppers.

1B. If your unit	is STAND	mounted:
A stand is	provided	and your	unit will bolt directly	to it.
An assembly DIAGRAM		is provided if stand assembly is		required.

An air operated FLOW CONTROL ASSEMBLY is provided for dispensing into a container. The purpose of this unit is to allow time for mixing to occur after each dispense. This flow valve keeps the mix chamber full to just below the sensor. This assembly bolts directly to the bottom of the Blender frame.

Page 8