CHECK OUT PROCEDURE
As you go through this procedure, if WHAT SHOULD HAPPEN, doesn't happen, see the next section, DIAGNOSTICS, for what to check.
NOTE: 100 and 200 series models (3K load cells), display all weight
readings in 1/10 grams ( x.x). 400, 900, and 1800 series models (10K load cells) display in FULL grams, no decimal.
On this page we show all weight readings WITH a decimal point.
Start with NO MATERIAL in any hoppers. Be sure an AIR SUPPLY is connected.
Place ALL switches DOWN; POWER (on front); STOP and PAUSE (on left).
PROCEDURE: | WHAT SHOULD | HAPPEN: | . |
PLUG IN CONTROLLER. | Nothing should happen. |
| |
| Air pressure should be holding ALL valves CLOSED. | ||
| This means all air cylinders are extended. If any | ||
| slide gate or flap is open, air lines are | ||
| reversed. |
|
|
TURN POWER ON. | Display should show ( FOUR | ), software type, | |
| followed by | version date (V=50920A), | |
| followed by | the check sum number (CKS xxxx), | |
| followed by | (ROM OK ), |
|
| followed by | (RAM = 8K), |
|
| followed by | (MODEL220) or MB, 140, 131, 122, 240, |
| 420, | 440, 940, 1840. (NOTE: | The MODEL | |
| number must match your unit, except for | |||
| the zero. If not see below.) |
| ||
| followed by ( | 0.0), |
|
|
| followed by the actual weight of material in the | |||
| bin. This number should | be close to 0, plus or | ||
| minus several | grams ( | 20.0) to (- | 20.0). |
AT THIS POINT: | Be sure the display is in tenths of grams, | |||
| or full grams | depending on your model. |
|
If the weight display is NOT correct, or the MODEL number is not correct;
see SELECTING CORRECT MODEL, next section.
TOUCH WEIGH BIN VERY LIGHTLY.
Display should update the weight every second reflecting the light pressure that you are exerting on the bin.
PRESS "*" KEY | Display will say (PASSWORD) |
| |
PRESS "22222" | (2 key five times) (entering | the Program mode) | |
| 2's will be displayed as you | enter them. | |
| Display will show (P | x.x) | when done. |
PRESS "OPER" KEY | Display will say (OPERATE ) |
| |
| Page 11 |
|
|