Henny Penny 680 KFC manual SMS Special Program, Review Usage, Mode

Henny Penny		Model 680
SMS PROGRAMMING	13.	After the filter value is set, press and release the Function
(Continued)		button. “EOC” and “EXIT” flashes on the left side
		of the display and “COOL” shows on the right side of the
		display. The end-of-cycle, (EOC), exit point can be set to
		COOL, SETP, or FITR, by pressing any of the product
		buttons (EOC). At the end of a cook cycle the controls
		can be set to return to COOL, the setpoint temperature, or
		to signal the operator to filter the shortening.
	14.	After the end-of-cycle point is set, press and release the
		Function button. “HEAD” and “COUNT” flashes on
		the left side of the display and a number shows on the
		right side of the display. The number on the right is the
		number of head of chicken to be cooked when that prod-
		uct button is pressed. The number can be changed by
		pressing the appropriate product button.
		NOTE
		Another product can be programmed while in the pro-
		gram mode by following these procedures:
		Press and hold the SCAN button at any time while in the
		Program mode and the display will scroll “SELECT
		PRODUCT”. Then press any of the product buttons,
		(1-0), and now that product can be programmed.
	15.	To program second interval, press and release the
		SCAN button while in the Time Mode of the first mode.
		“INIT 2” and “TIME” will flash on the left side of the display.
		Then follow the steps above, starting with step 4.
SMS SPECIAL PROGRAM		Review Usage
MODE	1.	Press and hold the Function button for two seconds until
		“REG PROGRAM” shows in the display. As soon as
		“REG PROGRAM” shows in the display, press and
		release the Function button 1 time until “REVIEW USE”
		shows in the display.
	2.	“DAILY” shows in the display. Press any of the Product
		buttons to view the usage of that product. Press and hold
		the Function button to exit Special Program mode.

1005 6-33