Henny Penny 680 KFC manual SMS Programming, IfApplicable, Code

Henny Penny		Model 680
SMS PROGRAMMING	1.	Press and hold the Function button for two seconds.
(IfApplicable)		“REG PROGRAM” will show in the display, followed by
		“CODE”.
	2.	Press the code 1,2,3. “SELECT PRODUCT” will scroll
		across the display.
		NOTE
		If no buttons are pressed, within approximately 1 minute
		while in the program mode, the controls will revert back
		to the cook mode.
	3.	Press the appropriate product button (1-0) to identify
		what product you want to program.
	4.	“INT1” and “TIME” will flash on the left side of the
		display. The right side will show the starting time of the
		cook cycle and can be changed by pressing the appropri-
		ate numbers. Ex: Press 1,0,0,0 and 10:00 will flash on the
		right side of the display, setting the start time at minutes.
	5.	After the time is set, press and release the Function
		button and “INT1” and “TEMP” will flash on the left side
		of the display. The right side will show the starting
		temperature and can be changed by pressing the appropri-
		ate numbers. Ex: Press 2,5,0 and “250° F” will show on
		the right side of the display, setting the start temperature
		at 250° Fahrenheit.
	6.	After the temperature is set, press and release the Function
		button and “INTI” and “PRESS” will flash on the
		left side of the display. Press any of the product buttons,
		(1-0), to turn the pressure on or off.
	7.	After the pressure is set, press and release the Function
		button and “INTI”, “LOAD”, and “COMP.” will

flash on the left side of the display. The factory preset load compensation value shows in the right side of the display.

1005 6-31