3.Locate wire nuts and disconnect leads.
4.Remove the screw securing the ignitor in the bracket and remove ignitor.
5.Make sure insulation is in place in the ignitor bracket and slide the probe through the slot in the bracket.
The probe, or tip of ignitor, is very fragile. Take care when installing the ignitor.
6.Secure ignitor in place with screw, reconnect wire leads and replace side panel.
‘7. Reconnect power and test the fryer for proper operation.
The nylatron strips fill the gap in the shroud behind the lid.
1.Secure the lid with the lid stop bracket.
2.Remove one of the
3.Lift the lid from the unit.
The lid weighs 80 lbs. Care should be taken when lifting the lid to prevent personal injury.
4.With one person on each lid arm, release arms from the lid stop bracket and allow lid arms to rise all the way up.