Henny Penny 680 KFC manual Melt Cycle Operation, Switches Indicators, Lo Mode, Cool Mode

Henny Penny	Model 680
3-3. MELT CYCLE OPERATION	If the shortening is below 185o F (77o-85oC) with the Power/
	Pump Switch in the “Power” position, the fryer enters the melt
	cycle. The shortening is heate slowly to prevent scorching of
	the shortening. The display reads “LO” and the heat cycles, 10
	seconde on, 30 seconds off, to ensure slow melting of shorten-
	ing. No othe rbutton on the control panel operates except the
	Power/Pump Switch.
	NOTE
	Should you require outside assistance, just call 1-800-417-
	8405, or 937-456-8405.
3-4. SWITCHES AND	NOTE
INDICATORS	If the fryer has the FAST controls, see the FAST
	operation manual.
“Lo” Mode	The display will read “LO” anytime the shortening temperature
	is below 250° F. When the Power/Pump Switch is placed in
	the “Power” position, the control will begin a melt mode which
	cycles the heat on and off. This slowly melts/heats the shorten-
	ing until the temperature reaches 185° F (85° C). This heat
	stays on until the “COOL” mode is reached, or until reaching
	the temperature of the selected cooking cycle.
“Cool” Mode
	After cooking or filtering the shortening, the temperature will
	automatically go into the “COOL” mode which keeps shorten-
	ing at 250° F (121° C). This temperature extends the shorten-
	ing life and minimizes the time needed to heat the shortening for
	the next cook cycle. Press “Exit Cool” to leave the “Cool”
	mode, then press product button for the cook cycle desired.
	To manually place the controls in the “COOL” mode, start a
	cooking cycle, and then press the cycle button again. The
	display should then show “COOL. See Cycle Selection below.
	Although the display will read “COOL” in the standby
	mode, the shortening is hot and could cause burns.

501 3-5