Care & Cleaning
Self-Clean Oven (select models)
Note: For manual clean oven, see page 21.
CAUTION
¥It is normal for parts of the range to become hot during a
¥To prevent personal injury and damage to the oven door do not attempt to open door when ÒLOCKÓ is displayed.
¥Avoid touching cooktop, door, window or oven vent area during a clean cycle.
¥Do not use commercial oven cleaners on the oven finish or around any part of the oven. They will damage the finish or parts.
The
It is normal for
During the cleaning process, the kitchen should be well ventilated to get rid of normal odors associated with cleaning.
Before Self-Cleaning
1.Turn off the oven light before cleaning. The light may burn out during the clean cycle.
2.Remove broiler pan, all pans, and oven racks from the oven. The oven racks will discolor and may not slide easily after a
3.Clean oven frame, door frame, area outside of gasket, and around the opening in the door gasket with a nonabrasive cleaner such as Bon Ami* or detergent and water. The
clean these areas. They should be cleaned to prevent soil from baking on during the clean cycle. (The gasket is the seal around the oven door and window.)
4.To prevent damage, do not clean or rub the gasket around the oven
door. The gasket is designed to seal in heat during the clean cycle.
5.Wipe up excess grease or spillovers from the oven bottom. This prevents excessive smoking,
6.Wipe up sugary and acidic spillovers such as sweet potatoes, tomato, or
Note: Oven temperature must be below 400° F to program a clean cycle.
To set Self-Clean:
1.Close the oven door.
2.Move door lock lever right to the locked position.
3. Press the Clean pad.
¥ ÒCLEANÓ flashes in the display.
If the door is not closed, beeps will sound and ÒDOORÓ will display. If the door is not closed within 45 seconds, the
4.Press the More+ or Less- pad.
¥
5.Press the More+ or Less- pad to scroll through
the
Choosing the soil level of the oven automatically programs the
6.After four seconds, the oven will start cleaning.
¥The cleaning time will start counting down in the display.
¥ÒLOCKÓ will appear in the display.
¥ÒCLEANÓ will appear in the display.
To Delay a Self-Clean Cycle:
1.Press the Delay pad.
¥ÒDELAYÓ flashes.
¥00:00 will appear in the display.
2.Press the More+ or Less- pad to set the amount of time you want to delay
the cycle. Delay time can be set from ten minutes (00:10) to 11 hours, 59 minutes (11:59).
cont.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
18