Amana ZRTC8500 Anti-tip Bracket Installation, Level Range, Removal and Replacement of Range

Page 7

Anti-tip Bracket Installation

To reduce risk of range tipping, secure range with a properly installed anti-tip bracket.

1.Measure 31/2 inches from back wall on right and left side of cabinet cutout. Mark measurements on floor and draw a straight line connecting marks.

2.Position anti-tip bracket.

If range is installed beside cabinet(s), place anti-tip bracket with back edge on line drawn on floor and side of bracket against cabinet.

If range is not installed beside cabinet(s), position range where it will be installed. Draw a line along side of range on floor from front to back. Remove range. Place anti-tip bracket with back edge over line drawn 31/2 inches from back wall and side of bracket over line drawn along side of range on floor.

Anti-tip bracket can be installed on either right or left side.

or

3.Mark 2 hole locations in anti-tip bracket.

4.Drill 2 holes.

If drilling into wood, use a 3/32 inch drill bit.

If drilling into concrete, use a 3/16 inch masonry drill bit and insert plastic anchors.

5.Secure bracket to floor using screws supplied.

6.Slide range into position.

7.Remove range storage drawer and confirm anti-tip bracket is engaged with range leveling leg.

Level Range

Carefully level range using legs provided. Range must be level to cook and bake uniformly.

CAUTION

To avoid damaging oven door, do not lift or move range by oven door handle. Glass can break.

Place a level on top oven rack or on top of range when leveling.

Leveling legs must be extended a minimum of

¼inch (6mm) to engage anti-tip bracket.

1.Extend leveling legs so when range is moved into position range top clears counter top.

2.Slide range to where it will be installed.

Position range so that rear leveling legs do not engage anti-tip bracket.

3.Turn leveling legs to level range.

Turn legs clockwise to decrease range height or counter clockwise to increase range height.

Adjust rear leveling leg that engages anti-tip bracket first. Leveling leg can not be adjusted while in bracket. After adjusting leg that engages anti-tip bracket, slide range forward until leg engages bracket, and adjust other legs.

4.Replace storage drawer.

Removal and Replacement of Range

1.Disconnect power to range.

2.Slide range forward.

3.Unplug range cord and place range aside.

4.Remove anti-tip bracket.

5.Install anti-tip bracket into new location using instructions provided with bracket or see “Anti-tip Bracket Installation” section in this manual.

6.To reinstall range, follow instructions in “Installation” section of this manual.

7

Image 7
Contents Customer Please Read Manual Before Operating Range InstallerContents Important Safety Information ALL Appliances Important Safety InformationInstallation Line Voltage Requirements Power Supply LocationMinimum Clearances to Combustible Surfaces Irregular Cabinet and Counter Top HeightsRemoval and Replacement of Range Anti-tip Bracket InstallationLevel Range Surface Elements SettingsOperation Preparing to Cook with Smoothtop ElementsConvection Broil BakeBroil Convection BakeElectronic Oven Control Options Electronic Oven ControlSpecial Oven Control Functions Timed Bake or Convection Bake Programming InstructionsQuick Reference Instructions Bake and Convection BakeTimed Convection Delayed Bake or Convection BakeDelayed Convection ConvectionConvection Dehydration Insta-Broil and Convection BroilDehydration Tips Canceling Self-Clean Cycle Self-CleaningInterrupt Self-Cleaning Cycle Delayed Self-CleaningService Tones and Codes Adjusting Oven Thermostat TemperatureUtensil Material Charateristics Type Temperature Uses ResponseUtensils Cooking UtensilsCooking Guide Oven Rack PlacementConvection Pan Placement Nonconvection Pan PlacementBaking Guide Food Oven temperature Cooking time Fahrenheit MinutesConvection Baking Guide Poultry Roasting Guide Food Oven Temperature Cooking time Fahrenheit HoursBeef and Pork Roasting Guide Convection Beef and Pork Roasting Guide Convection Poultry Roasting GuideConvection Broiling Guide Broiling GuideRemoving Oven Door Replacing Oven Light Care and CleaningRemoving Storage Drawer Replacing Panel Light BulbRemoving Coil Surface Elements Cleaning Part Materials to Use General Directions Problem Cause To Prevent To Remove Cleaning Smooth Top Range TopProblem Check Before Calling for ServiceCommon Questions Cooking Products excluding wall ovens WarrantyIdentification du modèle Table des matièresMise EN Garde Renseignements de sécurité importantsFeu d’élément de surface En cas d’incendieOuverture dans le comptoir Emplacement de la cuisinièrePrécautions EmballageHauteur irrégulière des meubles et des surfaces de travail Hauteur standard du comptoir et de l’appareilDégagements minimums des surfaces combustibles Spécifications relatives à la tension électrique Emplacement du bloc d’alimentationPose de la patte de stabilisation Retrait et remise en place de la cuisinière Mise de niveau de la cuisinièreCuisson au gril Allumés Réglages Fonctionnement du fourÉléments de surface Cuisson au four Cuisson au four Allumés Cuisson au grilCuisson à chaleur tournante Cuisson au four en mode chaleur tournanteCommandes électroniques Commandes électroniques du fourFonctions spéciales du four Programmation Cuisson au four et en mode chaleur tournanteFonctionnement du four en bref Cuisson différée ou en mode chaleur tournante Cuisson minutée ou en mode chaleur tournanteCuisson différée en mode chaleur tournante Cuisson minutée en mode chaleur tournanteLégumes Cuisson au gril ou au gril en mode chaleur tournanteDéshydratation en mode chaleur tournante Conseils pour la préparation de fruits et légumes secsAnnulation du cycle d’autonettoyage AutonettoyageAutonettoyage différé Interruption du cycle d’autonettoyageTonalités et codes d’entretien Réglage du thermostatRécipients de cussion RécipientsPlacement des plats en mode chaleur tournante Grille pour la cuisson au gril en mode chaleur tournanteGuide de cuisson Guide de cuisson de pain et de gâteaux Guide de cuisson de rôtis de boeuf et de porc Guide de cuisson de volaillesGuide de cuisson de volailles en mode chaleur tournante Guide de cuisson au gril Guide de cuisson au gril en mode chaleur tournanteEntretien et nettoyage Soulever Remplacement de l’ampoule fluorescenteRetrait du tiroir de rangement Retrait des éléments de surface à bobinePièces Matériel à utiliser Instructions générales NettoyageProblème Cause Prévention Remède Nettoyage du dessus de la cuisiniére à surface lisseQuestions courantes Avant d’appeler le technicienAppareils DE Cuisson Amana sauf les fours encastrés GarantiePart No.36-31817201-0