Test Mode - Testing Oven Parts
From screen 2 of the Info mode, press the L1 soft key to access TEST MODE. When prompted, enter the password 9 4 2 8 and press the Enter key.
From TEST MODE, the oven’s components can be tested independently, or a comprehensive/ selective
Top Blower
Press the L2 soft key to increase top blower speed in 10% increments.
NOTE: While the top blower is being tested, the bottom blower remains at 10% idle airflow.
Bottom Blower
Press the L3 soft key to increase bottom blower speed in 10% increments.
NOTE: While bottom blower is being tested, the top blower remains at 10% idle airflow.
Heaters
Press the L4 soft key to turn heaters on/off.
NOTE: When the heaters are not being tested, make sure they are turned off; otherwise, the oven will overheat.
Magnetron Test
Press and hold the L5 soft key to turn on the magnetrons. To turn off the magnetrons, simply let go of the L5 soft key.
Stirrer
Press the R1 soft key to turn the stirrer on/off.
L1 | TEST MODE | R1 | |||||
|
| ||||||
| FAULT LOG |
|
|
|
| STIRRER ON |
|
L2 | TOP BLOWER 10% |
|
|
|
| DIAGNOSTICS OFF | R2 |
L3 | BOTTOM BLOWER 20% | MANUFACTURING MODE | R3 | ||||
|
| ||||||
L4 | HEATERS ON |
|
|
|
| SELF TEST | R4 |
|
|
|
|
|
| ||
L5 | MAG OFF |
|
|
|
|
| R5 |
P S M t | H |
| B | T | W | ||
Figure 14: Test Mode
15
Test Mode - Status Indicators
Figure 14. The status indicators are located at the bottom of the TEST MODE screen, and consist of:
-P = Primary switch (backlit = open)
-S = Secondary switch (backlit = open)
-M = Monitor switch (backlit = open)
-t = Magnetron thermostat (backlit = open)
-H = Heaters (backlit = on)
-B = Bottom blower (backlit = on)
-T = Top blower (backlit = on)
-W = Microwave (backlit = on)
In Figure 14:
-All three door switches are engaged (closed).
-The heaters are on.
-Both blower motors are on.
-Microwave is not being used.
Test Mode - Fault Log
Press the L1 soft key to access the fault log.
This fault log is identical to the one accessible from screen 1 of the INFO MODE (page 13), except on this screen, pressing the 0 key clears all faults.
Test Mode - Turning On/Off
Diagnostic Mode
Press the R2 soft key to place the oven in
DIAGNOSTIC MODE. When in DIAGNOSTIC MODE,
the oven displays additional cooking parameters during a cook cycle, including:
-Event currently being cooked
-Time left per event
-% wave, % top air, % bottom air
-Status indicators
-Group and recipe name
-CC temperature
-CC set point
For normal oven operation, ensure DIAGNOSTIC MODE is turned off.
INFO MODE