Alamo DSEB-D16/SAS instruction manual Fill Hydraulic Tank with Oil

Fill Hydraulic Tank

Fill Hydraulic Tank with Oil:

1.DO NOT START TRACTOR untill you have filled Hydraulic Oil Tank to a level as shown in Sight Glass gauge and fill the Suc- tion Hose to Pump with Oil.

2.Remove Filler Cap. Remove Filler cap only when ready to fill hydraulic Tank with Oil. Do Not leave the Cap off and the system Open, always keep sytem closed when possible. Avoid any oil contamiantion.

(See Figure 1)

3.Avoid Hydraulic Contamination by filtering the Hydraulic Oil while filling the Hydraulic Tank. Filter buggies or carts are commercially available for Hy- draulic system clean-up and Oil transfer. These con- sist of high capacity filter, a Circulating Pump, a Drive Motor and hoses for connecting to the units hydraulic system. When adding Oil always use Clean new Oil from a sealed container, If you suspect the Oil of being contaminated don't use it. (See Figure 2 & 3). It is best to always use a filter system when adding even new oil.

4.When adding Oil in the field keeping it clean is critical, do not use dirting funnels or hoses. Do Not open Hydraulic tank or any contaners unless the openings have been cleaned first. The outside of the containers must be clean. If a windy dusty day do not fill and allow dirt to blow into oil. Always add Oil using a pump systemwith at least a 10 Micron filter system. (See Figure 4)

FIGURE 1

FIGURE 2

FIGURE 3

FIGURE 4

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 11 - 2