Alamo DSEB-D16/SAS instruction manual High Frame Installation

High Frame Installation

Frame Rail Pre-Assembly: (continued)

High Frame Mounting Tube Components. (See Figure 4) These Components are Sitting in approx. position of assembly to illustrate where they are to be when tack welding them. Space is left between them for Illustration only, they will be closer together when assembled.

Also See Figure 3 on previous Page.

Bolts (3 each side)

Angle Mount (2
each side)
	Mounting Tube
Frame	(1 each side)
Rail	Mounting Bolt Holes
	(2 each end)
Rear of
Frame Rail	Angle Mount
	(2 each side)
Bar Mounting	Front
Strap Cut Off
	of
(2 each side)
	Frame
Locknuts (3 each side)	Rail
Figure 4	Bar Mounting
	Straps

High Frame and King Post Frame Sub-Assembly. (See Figure 5) The High frame will come with the King Post Sub-Assembly built to it. The 2 Wheel drive and 4 Wheel Drive High frames are different and will not interchange between 2 WD and 4 WD Tractors, the 4 Wheel drive High Frame has the King Post Mounting welded higher up on frame than 2 WD Frame. DO NOT try to use a 2 Wheel drive Frame on 4 Wheel Drive Tractor or vice versa, it will not work.

Hydraulic Tank, The Hydraulic Tank is mounted on the LH side of High Frame. It will be mounted by the Mounting tubes that are welded to the High Frame and the Tubes that are welded on to the Hydraulic Tank. There will be long bolts with Allen Heads that will be inserted down through these tubes.

Tank Mounted Counter Weight. There is a tank mounted counter weight that will be mounted on to the Hydraulic Tank useing Allen Head Bolts. There will be a cover that bolts on over counter weight.

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 4 - 6