Alamo DSEB-D16/SAS Installing Wiring Harness to Joystick, Align the Plug Guides

Joystick Mounting 2 WD & 4 WD

Installing Wiring Harness to Joystick:

(Continued)

8.	Ground Wire. The Black
wire at the harness (See Figure

Battery	Shown here is typical Ignition
ACC Wire	connection, Your Ignition may
	vary but the function will not.
	Ignition

11 and 13) can be connected

inside the cab floor, or it can be

run down through the floor and

connected to the frame below

Starter

Tractor	Ignition
		Wire

the cab. If grounding to the Cab
floor connect ground now.
9.	Install Wiring Harness to
Joystick. Pull the Wiring Har-
ness up till it touches the bottom
of the Joystick connection (See
Figure 14). Align the Plug Guides
(there are 1 wide and 2 narrow
lugs) that prevent the plug from
being installed wrong. Screw the
plug retainer onto the Joystick
Plug, this will be hand tightened.

Tractor

Ignition Switch

Brown	Wire
	Red

Joystick Wiring

Harness

	Harness				of	Harness
of		Harness
Wire	of		Wire
		Brown
							Wire
				Black

	Cut Tractor Starter
	Wire to Starter Sole-
Ground	noid and	reroute
	through	Joystick
	Harness	Brown
	wires.

FIGURE 13

FIGURE 14

FIGURE 15

10.Reinstall Floor Mat. DO NOT cut Floor Mat. Make sure you have remounted the wire harness protector over wire harness under floor mat (See figure 8). Push the wire harness over against the side panel (See Figure 15). Put the floor mat down as it was originally. When finished floor mat should be as smooth as it was before installation.

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 9 - 6