Alamo DSEB-D16/SAS instruction manual 24-1/2 Min Height frame to Hood High Frame Frame Rail

Frame Rail Installation

Pre-Installing High Frame: (continued)

4.Lower High frame down over Tractor. This is a two man job in order to keep control of High Frame on both sides of tractor (See Figure 25). Lower the High Frame down over the Frame rails (See Figure 26) slowly, as it must straddle the Frame Rails (See Figure 26). Lower High Frame untill the top of the High Frame is no higher than the cab of The Tractor max. and no lower than 24-1/2" from frame to hood as the min. distance (See Figure 25) . Another mark to look at is the Horizontal tube of the High frame should be parallel up and down with the Frame Rail Tube as shown on next page (See Figure 29).

5.Check High Frame for Level. Check the two Magnetic Levels that you installed earlier. The Top Level should be from side to side of the Tractor (See Figure 27). The level on the King Post Pivot Pin should be level making High Frame Level straight up and Down (See Figure 28). Leave the Magnets on the High frame, as you will have to check then one more time later. DO NOT do any welding at this time.

6.Secure High Frame to Frame Rails. Secure the High Frame to the Frame rails with C-Clamps on both sides (See Figure 29). Do not weld anything at this time.

24-1/2"

Min

height frame to Hood

Figure 25

High Frame

Frame Rail

Figure 26

	Level	Level
Figure 27	Figure 28
A-Boom(JD 6615/ 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.	Section 4 - 13