Alamo DSEB-D16/SAS instruction manual Installing Wire Harness, To Valve

Wire Harness / Valve Mounting 2 WD & 4 WD

Installing Wire Harness

To Valve: (Continued)

5.Wire Harness Terminal Identification. The Wire Harness Terminal Plugs are marked in writ- ing on the plug. Swing, Lift, Dipper, Tilt and Door terminal plugs (5 Total). The Valve terminals are in this same order starting at the bottom and coming up on the valve. You will need to have a short handle Phillips screwdriver for this. (See Figure 26).

6.Wire Harness Terminal Installation. You will need to feed wire harness under the fitting across tank (See Figure 24) lay the Plugs out in the Order they are to be installed starting at the bottom terminal.

7.Terminal Connections. Make sure that each terminal Plug on Valve has had the Gasket in- stalled on it, then Install Swing Terminal and tighten Plug Retaining Screw. Continue this with all 5 plugs starting at the bottom and coming up (See Figure25)

	PLUG	FUNCTION
1	Bottom Plug	Swing Terminal
2	2 nd Plug Up	Lift Terminal
3	3 rd Plug Up	Dipper Terminal
4	4 th Plug Up	Tilt Terminal
5	Top Plug	Door Terminal

Connect and tighten all 5 terminal plugs one at a time till all 5 are connected. (See Figure 26)

Photo without Pump & Hoses

shown for illustration only

Door

Tilt

Dipper

Lift

Swing

FIGURE 25

Plug Gaskets

FIGURE 23

Terminal

Plugs

FIGURE 24

Short Handle

Phillips

Screwdriver

FIGURE 26

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 9 - 9