A.O. Smith 28 30 50 60 Installation, Introduction Packaging Environmental conditions

is

3

3.1Introduction

3.2Packaging

3.3Environmental conditions

Introduction

Installation

Warning

The installation should be carried out by an approved installer in compliance with the general and local regulations imposed by the gas, water and power supply companies and the fire service.

The appliance may only be installed in a room which complies with the requirements stated in national and local ventilation regulations.

Refer also to paragraph ’1.3 Regulations’.

This chapter describes the installation activities to be carried out before the appliance may be started up, namely:

•Packaging;

•Environmental conditions;

•Technical specifications;

•Water connections, Unvented;

•Water connections, Vented;

•Gas connection;

•Air supply and flue gas discharge;

•Electrical connection;

•Checking the supply pressure and burner pressure;

•Conversion to a different gas category.

nRemark

Starting up the appliance is described in chapter ’7 Starting up and shutting down’.

To avoid damaging the appliance, remove the packaging carefully. We recommend unpacking the appliance at or near its intended location.

cNote

The appliance may only be manoeuvred in an upright position. Take care that the appliance is not damaged after unpacking.

The BFC appliance is a room-sealed appliance. Installation types possible with this appliance are C13, C33, C43, C53 and C63. This makes it possible to install the appliance in either a closed or an open boiler room.

Release R.1.3 UK 17