Functional Verification: Gate In Test
Description
The purpose of this test is to check the gating func tion. The "TRIG OUT"
port of the Command Module is used to gate th e output.
Test Procedure
1. Reset the AFG:
*RST;*CLS Reset AFG and clear
status registers
2. Set up the equipment as shown in Figure 2-3.
3. Send the following commands to the Command Module to enable the
"Trig Out" port:
*RST
OUTP:EXT:STAT ON
OUTP:EXT:SOUR INT
Figure 2-3. Gate In Test Setup
Agilent E1445A Service Manual Verification Tests 23