CLOCK

AND TIMER

SETTING THE CLOCK

CLOCK

i/k

ENTER

SHIFT

r,t

CURSOR

 

s

s

a

a

 

r,t

 

ENTER

1Press a or ENTER while the power is off.

Alternatively, press CLOCK while pressing SHIFT while the power is on or off.

The clock is displayed. (Or the clock becomes brighter.)

When the power cord is plugged into an AC outlet for the first time after purchase or when the clock setting is canceled due to a power failure, the entire clock display flashes.

2Within 4 seconds, start setting the time.

Press r or t.

Alternatively, move CURSOR on the main unit ior k, or press i/k on the remote control.

Holding these buttons down will vary the time in 10-minute units.

3Press a or ENTER.

The clock starts from 00 seconds.

When the clock is set for the first time after purchase

Everything on the display will clear.

This is because the power economizing mode is activated, and is not a malfunction.

The power economizing mode can be canceled. See page 10 for details.

To view the clock when another display is in the display

Press CLOCK while pressing SHIFT on the remote control. The time is displayed for 4 seconds and then the original display reappears.

To switch to the 24-hour standard

Press CLOCK while pressing SHIFT on the remote control, and then press s within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

In the 12-hour standard, "AM 12:00" indicates midnight and "PM 12:00" indicates noon.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.

SETTING THE SLEEP TIMER

SLEEP

SHIFT

r,t

CURSOR

r,t

The unit can be turned off automatically at a specified time.

1Press SLEEP while pressing SHIFT.

Alternatively, press MODE on the main unit repeatedly until "SLEEP" is displayed.

2Within 4 seconds, press r or t to specify

the time until the power is turned off.

Alternatively, move CURSOR on the main unit i or k.

The time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off

Press SLEEP once while pressing SHIFT. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that "SLEEP OFF" appears on the display.

When operating on the main unit, press MODE repeatedly until "SLEEP" is displayed. Then move CURSOR i or k so that "SLEEP OFF" is displayed.

36 ENGLISH

Page 38
Image 38
Aiwa XR-DV3M operating instructions Setting the Clock, Setting the Sleep Timer