22 AMD Geode™ SC2200 Processor Data Book
Architecture Overview
32580B

2.1.2 Fast-PCI Bus

The GX1 module communicates with the Core Logic mod-
ule via a Fast-PCI bus that can work at up to 66MHz. The
Fast-PCI bus is internal for the SC2200 and is connected to
the General Configuration Block (see Section 4.0 on page
75 for details on the General Configuration Block).
This bus supports seven bus masters. The requests
(REQs) are fixed in priority. The seven bus masters in order
of priority are:
1) VIP
2) IDE Channel 0
3) IDE Channel 1
4) Audio
5) USB
6) External REQ0#
7) External REQ1#

2.1.3 Display

The GX1 module generates display timing, and controls
internal signals CRT_VSYNC and CRT_HSYNC of the
Video Processor module.
The GX1 module interfaces with the Video Processor via a
video data bus and a graphics data bus.
• Video data. The GX1 module uses the core clock,
divided by 2 or 4 (typically 100 - 133 MHz). It drives the
video data using this clock. Internal signals VID_VAL
and VID_RDY are used as data-flow handshake signals
between the GX1 module and the Video Processor.
• Graphics data. The GX1 module uses the internal
signal DCLK, supplied by the PLL of the Video
Processor, to drive the 18-bit graphics-data bus of the
Video Processor. Each six bits of this bus define a
different color. Each of these 6-bit color definitions is
expanded (by adding two zero LSB lines) to form an
8-bit bus, at the Video Processor.
For more information about the GX1 module’s interface to
the Video Processor, see the “Display Controller” chapter
in the AMD Geode™ GX1 Processor Data Book.
2.2 Video Processor Module
The Video Processor provides high resolution and graphics
for a CRT or TFT/DSTN interface. The following subsec-
tions provide a summary of how the Video Processor inter-
faces with the other modules of the SC2200. For detailed
information about the Video Processor, see Section 7.0
"Video Processor Module" on page 319.

2.2.1 GX1 Module Interface

The Video Processor is connected to the GX1 module in
the following way:
•The Video Processor’s DOTCLK output signal is used as
the GX1 module’s DCLK input signal.
•The GX1 module’s PCLK output signal is used as the
GFXCLK input signal of the Video Processor.

2.2.2 Video Input Port

The Video Input Port (VIP) within the Video Processor con-
tains a standard interface that is typically connected to a
media processor or TV encoder. The clock is supplied by
the externally connected device; typically at 27 MHz.
Video input can be sent to the GX1 module’s video frame
buffer (Capture Video mode) or can be used directly (Direct
Video mode).

2.2.3 Core Logic Module Interface

The Video Processor interfaces to the Core Logic module
for accessing PCI function configuration registers.

2.2.4 CRT DAC

The Video Processor drives three CRT DACs with up to
135M pixels per second.
The interface for these DACs can be monitored via external
balls of the SC2200. For more information, see Section
3.4.4 "CRT/TFT Interface Signals" on page 56.