AMD SC2200 manual Stop#, Lock#, Devsel#, Bhe#

Signal Definitions 32580B

3.4.6PCI Bus Interface Signals (Continued)

Signal Name	BalL No.	Type	Description	Mux
STOP#	G1	I/O	Target Stop. STOP# is asserted to indicate that the cur-	D15
			rent target is requesting that the master stop the current
			transaction. This signal is used with DEVSEL# to indicate
			retry, disconnect, or target abort. If STOP# is sampled
			active by the master, FRAME# is de-asserted and the
			cycle is stopped within three PCI clock cycles. As an
			input, STOP# can be asserted in the following cases:
			1) If a PCI master tries to access memory that has
			been locked by another master. This condition is
			detected if FRAME# and LOCK# are asserted dur-
			ing an address phase.
			2) If the PCI write buffers are full or if a previously buff-
			ered cycle has not completed.
			3) On read cycles that cross cache line boundaries.
			This is conditional based upon the programming of
			GX1 module’s PCI Configuration Register, Index
			41h[1].
			This signal is internally connected to a pull-up resistor.
LOCK#	H3	I/O	Lock Operation. LOCK# indicates an atomic operation	---
			that may require multiple transactions to complete. When
			LOCK# is asserted, non-exclusive transactions may pro-
			ceed to an address that is not currently locked (at least
			16 bytes must be locked). A grant to start a transaction
			on PCI does not guarantee control of LOCK#. Control of
			LOCK# is obtained under its own protocol in conjunction
			with GNT#.
			It is possible for different agents to use PCI while a single
			master retains ownership of LOCK#. The arbiter can
			implement a complete system lock. In this mode, if
			LOCK# is active, no other master can gain access to the
			system until the LOCK# is de-asserted.
			This signal is internally connected to a pull-up resistor.
DEVSEL#	E4	I/O	Device Select. DEVSEL# indicates that the driving	BHE#
			device has decoded its address as the target of the cur-
			rent access. As an input, DEVSEL# indicates whether
			any device on the bus has been selected. DEVSEL# is
			also driven by any agent that has the ability to accept
			cycles on a subtractive decode basis. As a master, if no
			DEVSEL# is detected within and up to the subtractive
			decode clock, a master abort cycle is initiated (except for
			special cycles which do not expect a DEVSEL#
			returned).
			This signal is internally connected to a pull-up resistor.

AMD Geode™ SC2200 Processor Data Book 59