3.10 Protocol Configuration
To access the Protocol Configuration Menu, enter the letter r from the Configuration Menu. Use the listed command letters to configure Simple Network Management Protocol (SNMP) and Spanning Tree Protocol (STP).
IntraCore
<Cmd> | <Description> |
n | SNMP Configuration |
sSpanning Tree Configuration
q Return to previous menu
root>
3.10.1 SNMP Configuration
To access the SNMP Configuration Menu, enter the letter n from the Protocol Configuration Menu. Use the listed command letters to configure the community strings, trap authentication, and the trap receiver.
IntraCore | |||
SNMP | Read | Community: | public |
SNMP | Write Community: | private | |
Trap | Authentication: | Disabled | |
SNMP | Trap | Receivers: | Community |
1. | IP Address | ||
<empty> | <empty> | ||
2. | <empty> | <empty> | |
3. | <empty> | <empty> | |
4. | <empty> | <empty> | |
<Cmd> |
| <Description> | |
r |
| Set SNMP Read Community | |
w |
| Set SNMP Write Community | |
t |
| Toggle Trap Authentication Enable/Disable | |
a |
| Add/Update SNMP Trap Receiver | |
d |
| Delete SNMP Trap Receiver | |
q |
| Return to previous menu | |
root>
Changing Community Strings
Important! Be sure to change the SNMP community strings in order to prevent unauthorized access to management information.
To change the switch’s community strings, use the following procedure:
1.Open the SNMP Configuration Menu by typing n in the Configuration Menu.
2.To change the read community string, type r. To change the write community string, type w.
3.At the prompt, type a new community string.
For a description of read and write community strings, see the following table:
30
