![](/images/new-backgrounds/1295370/29537039x1.webp)
2 Installing Your System | Quick Reference Guide | |
|
|
|
|
|
|
Wall-Mounting a 5-Slot Carrier and Modules
Install the
The location of each module within the carrier is important; place the modules as instructed in the following procedure.
Follow these steps to
1Using the enclosed template, mark the screw locations on the wall. If you are mounting the carrier on plywood, start four #12 screws supplied with the carrier, leaving the screw heads extending approximately 1/4 inch (0.64 cm) from the wall. If you are mounting on drywall, use wall anchors, which must be purchased separately.
2Before installing any modules, make sure the clear, plastic protector has been removed from the connector area on the rear of each module. To remove the protector, grasp the tabs on the ends of the protector and lift.
3Insert the PARTNER ACS processor module in the center slot of the carrier.
4In the other slots, from left to right, first install the 1600 DSL module (if used), then the 012E, 308EC, or 206 modules, followed by the 400 or 200 modules and/or a PARTNER Messaging or PARTNER MAIL VS module. Align the module carefully in the appropriate slot. For proper engagement of the connectors, the module must be inserted straight into the carrier. Once the module is properly seated, firmly push the center of the module until the connectors on the module lock into place. A slight click indicates the connectors are engaged.
10 Installing the Control Unit