Avaya 700217243 manual Programming Mode, Changing Programming Type

3 Setting Up Your System Quick Reference Guide

Programming Mode

When you are ready to program a system or telephone feature, you must enter programming mode. Follow these steps to enter programming mode.

1Place the Programming Overlay over the dialpad of the system display telephone at extension 10 or 11.

2To enter programming mode, press f00.

3Press s.

4Press sagain.

5Specify a programming procedure in one of two ways:

•Direct Method: Dial the code for that procedure. System Programming procedures in this guide are identified by a # and a three-digit code (for example, System Date is #101). This method is best when you are using only a few procedures during a programming session and you know the codes.

•Cycle Method: Cycle through the procedures in numerical order. Press Nand Pto cycle forward and backward through the programming procedures. This method is best when you are using multiple procedures during a programming session, or if you do not know the codes.

6To exit programming mode, you can press f00. Or you can lift the handset and then place it back in the cradle.

Changing Programming Type

When you are in programming mode, you can move between System Programming and Centralized Telephone Programming. To change to Centralized Telephone Programming when you are in System Programming, press c. To move back to System Programming when you are in Centralized Telephone Programming, press c, then s.

24 System Programming Basics