Quick Reference Guide | 6 Maintaining Your System | |
|
|
|
|
|
|
6In Release 3.0 or later systems, the LEDs on the processor module (center slot) will alternate red/green while the upgrade is being performed. When the upgrade is finished, the LED will appear steady green. Make sure each module has a green LED in the same horizontal area, and that they all appear steady green. This indicates that each module is powered up.
PARTNER ACS Release 5.0 or later provides a firmware upgrade capability for the 1600 DLS and 012E modules. If you are performing a firmware upgrade of either of these modules, see “Upgrading 1600 DSL and 012E Module Firmware” on page 62 for a description of how the LEDs appear during the upgrade.
•If a single light is out, power down the control unit, reseat the module and power up the control unit.
•If multiple lights are out, power down the control unit, reseat the leftmost module that has a light out, and power up the control unit.
•If the lights are still out, call for support as instructed on the inside front cover of this guide.
7Follow the procedures below:
aIf you are upgrading from Release 1.0 to Release 2.0, power down and remove the PC upgrade card.
aIf you are upgrading to Release 3.0 or later, do not remove the PC card. The card automatically converts to a backup/restore and remote access card. If you removed other PC cards, PVM or ASA/DXD, for example, power down the system and reinstall the PC cards after the upgrade is complete.
8If you have a
9Make sure all modules are seated properly. (For Release 3.0 and earlier systems, the cover will not fit if the modules are not seated properly.) If you have a system of Release 4.0 or later, you are finished with this procedure. If you have a system of Release 3.0 or earlier, continue with Step 10.
10To replace the cover, grasp it by its upper edges and hold it squarely over the control unit. Place the cover over the modules and make sure it fits firmly in place.
Using a PC Card 61
