| Button Programming: Button Functions | ||
|
|
|
|
Privacy | This function allows you to turn privacy on or off. When on, other extensions are not able to |
| |
| bridge into your calls. |
| |
|
|
| |
Recall | This function allows you to send a recall or hook flash signal. |
| |
|
|
| |
Saved Number Redial | This function allows you to save the number dialed during a call and to redial that number when |
| |
| idle. This can be used when the number dialed does not answer. |
| |
|
|
| |
Station Lock | This function allows you to lock and unlock your extension from being used to make calls. When |
| |
| selected, you are prompted to enter a four digit code after which the extension is locked. If the |
| |
| extension is already locked, use of this function prompts for reentry of the four digit code to |
| |
| unlock the extension. |
| |
|
|
| |
Station Unlock | This function can only be used by the first two extensions in the system. It allows the user to |
| |
| unlock any extension without needing to know the code that was used to lock that extension. |
| |
|
|
| |
VMS Cover | This function allows the you to switch use of voicemail coverage for your extension on or off. |
| |
|
|
| |
Voice Mailbox | This function allows you to transfer your current call to another extension's mailbox. Your |
| |
Transfer | current call is put on hold and you enter the target extension number to indicate the mailbox |
| |
| required. |
| |
|
|
| |
Wake Up Service | A Wake Up Service button can be assigned for the first extension on the system. Using this |
| |
| button, the extension user can set wake up calls within the next |
| |
| extension. |
| |
|
|
|
|
Function Status Indication
For some functions, for example those that can be on or off, the icon or LED in the programmable button will indicate the current status of the function.
To activate and deactivate one of the following features using a programmable feature button,press the button and follow the onscreen prompts. During feature activation and deactivation, the status LED on the associated programmable feature button does not reflect the current state of the feature. However, upon exiting the feature activation/deactivation screen, the new state of the feature is shown by the programmable button's status LED.
∙Absent Message
∙Account Code Entry
∙Call Log
∙Wake Up Service Button
∙Station Lock
∙Station Unlock
∙Night Service (when a system password has been administered)
∙Caller ID Inspect
IP Office Basic Edition - Quick Mode 9500 Series Phone User Guide | Page 55 |
IP Office Basic Edition | - Issue 6b (23 November 2011) |
