Barco E1 manual Installing the BarcoMed Nio display controller, PCI and RAID Controller Slots

Display controller installation

Figure 5: PCI and RAID Controller Slots

Installing the BarcoMed Nio display controller

Install the BarcoMed Nio controller in your computer following these steps:

1.Turn off the power to your computer and disconnect the power cord, however make sure that the computer chassis is still grounded.

2.Remove the chassis cover according to the manufacturer’s instructions. Be sure to observe safety warnings.

3.If you have decided to use the on-board VGA capabilities of the BarcoMed Nio (see Using the VGA capabilities of the BarcoMed Nio display controller on page 23), you must now remove any VGA display controller(s) that are currently installed in the computer or disable any VGA controllers that are integrated into your PC’s motherboard.

4.Install the BarcoMed Nio display controller into a free PCI slot, either 64-bit or 32-bit (see figure 5 above, for examples of slots). Be sure that the display controller is seated firmly in the slot.

5.Secure the card to the chassis with the PC’s I/O panel mounting screw, and replace the chassis cover.

System manual E1 25