Barco E1 manual Running multiple BarcoMed Nio Display Controllers in a single host

Display controller installation

6.Connect the primary display to the connector marked “VID 1” on the BarcoMed Nio display controller using the provided DVI cable (see figure 6 below). For a dual-headed BarcoMed Nio setup, connect the secondary display to the other connector on the display controller.

7.Reconnect the power cord, turn on the power, and boot the system as usual.

Running multiple BarcoMed Nio Display Controllers in a single host

The physical order of the displays may vary when you are running multiple BarcoMed Nio display controllers. This is due to the PC’s PCI bus control in the system BIOS, and not the BarcoMed display controller. It may become necessary, depending on how your PC’s BIOS configures the PCI bus, to switch your DVI display connections to achieve a linear desktop configuration.

Figure 6

26 System manual E1