Installation
Adjustments
Before applying power to the appliance for the first time, check for the following conditions:
jAll electrical safety provisions have been ad- hered to and the electrical connections are correct.
jThe bake enhancer and holder are in their proper positions.
jThe pan holders are inserted into the oven cavity.
DOOR ADJUSTMENT
The door catch may be adjusted in two directions, in and out, and up and down, using the following procedure:
1.Adjust up and down by loosening the two bolts holding the catch to the face of the ap- pliance. See Figure 10 (A).
2.Make adjustments so that the leading face of the latch is centered in the opening of the han- dle assembly.
3.Tighten the bolts so that there is no further movement.
4.Adjust in and out by loosening the bolt on top of the catch. See Figure 10 (B).
5.The adjustment face is stepped so that move- ment is limited with the bolt tightened properly.
6.The adjustment is correct when the door closes firmly and no steam leaks from the gas- ket.
The hinges can also be adjusted as follows:
1.Be certain the latch is adjusted properly.
2.Adjust hinges so that the door back and the appliance face are parallel. See Figure 10 (C).
3.The adjustment is correct when no steam leaks through the gasket.
| Door |
| C |
B | Oven |
| |
| A |
Figure 10
14
